Sensors Circuit Board

This part is a Balboa Heater M7 Sensor. This Sensor comes with the wire, Connector, and The Screw down cap. It DOES NOT include the tube and the tube side mount. You will normally not need the sensor mount you would reuse it so there is no reason to have...

This part is a Standard Balboa Heater M7 Sensor with a 24" wire. This Sensor comes with the wire, Connector, and The Screw down cap. It DOES NOT include the tube and the tube side mount. You will normally not need the sensor mount you would reuse it so...

This Part is the O-ring used to seal the Temperature Sensor On Sundance and Jacuzzi Brand Hot Tubs Only.. Note: Temperature Sensor is sold separately..  The sensor this O-Ring Fits are used with Some Jacuzzi Premium Hot Tubs and the following...

This Part is a Thermodisc Style Surface Mount HI LIMIT: Single Pole Single Throw THERMAL FUSE Auto Reset (With NO CAPILLARY)This Hi Limit Surface mount surface mounts to the heater in a spot where it can read what the actual water temperature is flowing...

This part is a Sensor, Hi Limit, HydroQuip, 18", 1/4"diameter, 2-pin, After 5/03, 6200, 6220, 6230, 6330, 7500, 9700 series control systems..   Sensor Application Spa Control Sensor Type Hi Limit Application HydroQuip Model 2 Pin After 5/03...

This Temperature Sensor Set has 1/4" probe widths on both probes.. This set usually found on tubs with no heater that uses a firestick or heat jacket to heat not a real heater... I have seen these on Dreammaker and other brands... The temp probe is...

This is a Thermcore Plastic replacement sleeve. The Stainless Steel version is no longer available.. Sensing Bulb Size 5/16" Depth 4" Plumbing Connection Size "A" 1/2" Plumbing Connection Type "A" Male Pipe Thread (mpt)

Temperature&Hi Limit Sensor

For 6100, 7100, 710, 9100, 8400, 8600, 9400, and 9600 systems

Temperature SensorFor 6100, 8400, 8600, 9400, & 9600 Series Systems