Wet End Pump Parts

This video is about a Jacuzzi J Pump Repair Kit How To Information...This type of pump can be found in many brands of hot tubs like, Jacuzzi, Jacuzzi Whirlpool,Blue Ridge, Gatsby, Whitewater, Echo, Hercules, Polynesian and many more... Wet End, Jacuzzi...

In this Video the Spa Guy show you how to install a 200 seal in an Aqua-Flo Wet End.. This is the seal only version... For the full version look in The Spa Guy's How To Video Library... Save Save Save Save Save Save Save Save Save Save Save Save Save...

This part is a replacement wear ring found in 48 frame 1 1/2" Flo-Master "FMHP" Series Side Discharge and "FMCP" Center Discharge Spa Pumps.. The ring measures about 1 3/4" inside the wear ring and 2 3/16" at the widest part and about 3/4" tall.. ...

This Wear Ring only fits Waterway Executive 1, 2, or 3HP Impellers for a 48 or 56 Frame Pump Wet Ends and measures 1-1/16" thick from front to back... If you have a Waterway Executive 4 or 5 Horsepower Wet End it will require a different wear ring that...

Seal Plate for Vico Ultima pumps. Material Type    PlasticVolute to Seal Plate Mounting Type    4 Bolts 4 NutsVolute to Seal Plate Hole Spacing    4-3/8"Seal Plate to Motor Mounting Type    48...

This parts is an Executive 2 1/2" Mpt Threaded Face plate assembly (Which will measure about 3 11/16" Across the Threads) less the O-rings, Screws, Bleeder Plugs and other hardware needed to attach it to the volute..There is another version of the face...

This part is a Wear Ring for a Hi-Flo Impeller found in Waterway Hi-Flo pumps only.. The Inside Diameter of the wear ring is 1 13/16"...

This parts is an Executive 2" Threaded Face plate assembly (Which will measure about 3" Across the Threads) less the O-rings, Screws, Bleeder Plugs and other hardware needed to attach it to the volute..There is another version of the face with a 2 1/2"...

This part is a face plate drain plug for Aqua-Flo pumps.. It does not come with an O-Ring you will find the link to that below.. Aqua-Flo Pump, Drain Plug, O-Ring Xp2, Xp2e, XP3, 7/16" ID, 3/32"  

 This part is the slinger found between the impeller and wet end and the shaft going into the pump motor bearing area and is designed to sling water away from the bearing in case of a seal leak at the wet end.. Note: It has to be placed on the motor...