Complete Heaters

This Part is a Surface Mount Style HI LIMIT: Single Pole Single Throw THERMAL FUSE Auto Reset (With NO CAPILLARY)This Hi Limit Surface mount surface mounts to the heater in a spot where it can read what the actual water temperature is flowing through the...

This item is a 1/8" MPT Brass Plug which can be used to block an 1/8" MPT (male Pipe Thread) hole normally found on a Heater Tube on Hot Tubs. This hole size is the same size as a Pressure Switch hole and would measure about 3/8" wide across the hole or...

This part is a Jumper Strap Set of (2) Kit to connect the heater to the circuit board on Balboa LE and Value Systems. Measures 1-3/8" x 13/16" Circuit Board Application    Balboa Water GroupCircuit Board Model    LE, Value...

This item is a 1/8" MPT Plug which can be used to block an 1/8" MPT (male Pipe Thread) hole normally found on a Heater Tube on Hot Tubs. This hole size is the same size as a Pressure Switch hole and would measure about 3/8" wide across the hole or the...

This Part is a Single Jumper Strap for a Balboa, EL, VS, GL or GS, Heater to Board connection.. This part is made from Copper.. Measures 2" x 13/16" Circuit Board Application    Balboa Water GroupCircuit Board Model    EL,...

The Spa Guy is talking here about the ins and outs of wiring a GFCI Breaker. Please consult your local codes for actual wiring rules...  #sparepair #hottubrepair  #hottubhowto Save

In this video The Spa Guy shows actual voltage in the water on a hot tub and what caused it. a Missing ground on the GFCI box when the hot tub was wired!! Once again The Spa Guy Saves the Day!! Your Hot Tub Super Hero  #sparepair #hottubrepair...

This video is about The Spa Guy teaching you the basics of GFCI Hot Tub Wiring and the ins and outs of wiring a Hot Tub...  #sparepair #hottubrepair  #hottubhowto Save

This video is The Spa Guy teaching you how to Diagnose a New Wire Up Situation where you just wired your hot tub up and it is tripping the breaker and it is either a new tub or it is used and ran fine at the last location...... Save

This video is about The Spa Guy diagnosing a Breaker Tripping on a Hot Tub With Hydro-Quip Controls... How To Replace the Heater Element and final diagnostic verification of operation.... Save

This video is about The Spa Guy showing How To Remove a Heater Element where the nuts are spinning in the tube and will not turn off...... it is a similar process on all brands... Save

This part is a 2 1/2" Thread X 1" 90 Degree Barb Heater Union with Gasket that matches Union. The Union receives a 1" ID pipe on the barb side and then Screws to a 2 1/2'" Heater Flange using a 2 1/2" Nut on the heater side. This...