Shop

This part is a complete New Old Stock Heater that was used on some Icon or Jumpking Hot Tub and Others.. Stainless steel, 1-1/2" x 8-1/2", 1.0kW/115v replacement heater with ground lug, (2) 1-32 x 3/8" mounting studs, and split nuts. The element is...

These blowers come with a 3 pin male AMP connection on a 3Ó pigtail, along with a 3 and 4 pin amp extension cord. Please use one of the recommended cord adapters for other types of connections to the control box. Splicing the pigtail and wire-nutting the...

Features:Adaptability: The Millenium is small and lightTranquility: The Millenium motor rubber mounts absorb 95% of the motor vibrationPerformance: Twice as powerful as a conventional blowerMemory: The Millenium blower can use a wide variety of air or...

This part is a Complete 3HP Aqua-Flo 2" x 2" ( Which measures about 3" Across the Threads) Side discharge 48 frame wet end for XP2 pumps. This wet end is used with a 48 frame motor that would have about 12.0 Amps on High Speed on a 230V motor and...

This pump is a Waterway Genesis Generation Energy Efficient Bath Pump 5.5 amps 115 Volts w/Air Switch The Plumbing connections are 1 1/2" on the Pressure and Suction sides which measure about 2 3/8" across the threads.. There are two barbed fittings on...

This part is a Complete 2.5HP Aqua-Flo 2" x 2" ( Which measures about 3" Across the Threads) Side discharge 48 frame wet end for XP2 pumps. This wet end is used with a 48 frame motor that would have about 11.0 Amps on High Speed on a 230V motor and not...

Balboa Water GroupStainless steel replacement heater assembly, 4.0kW, 230v or 115v, the inside Diamater of the tube is 2" and the overall length of the tube is 15" not including the split nuts on each end. This comeplete heater includes M7 sensors,...

This part is a Complete 1.5HP Aqua-Flo 2" x 2" ( Which measures about 3" Across the Threads) Side discharge 48 frame wet end for XP2 pumps. This wet end is used with a 48 frame motor that would have about 9.0 Amps on High Speed on a 230V motor or 13.0...

You are buying a 4 HP 56 Frame Waterway Executive 2 1/2" X 2" Wet End / Pump complete with Screws, Volute, Impeller, Seal, Face and the Wear Ring. The difference between a 48 or 56 Frame wet end is the spacing of the Motor Thru bolts. The 48 Frame will...

Balboa Water GroupStainless steel replacement complete heater assembly, 5.5kW, 230v or 115V.Thie heater measures 2" Inside Diameter of the tube and the length of the tube is 15". Includes M7 sensors, tailpieces, split-nuts and gaskets. Made for Balboa VS...

Stainless steel aftermarket replacement heater assembly fits systems using a pressure switch. 5.5kW/240v with 1/8"npt pressure switch tap. 2" x 15" manifold includes tailpieces

This part is a Complete 2HP Aqua-Flo 2" x 2" ( Which measures about 3" Across the Threads) Side discharge 48 frame wet end for XP2 pumps. This wet end is used with a 48 frame motor that would have about 10.0 Amps on High Speed on a 230V motor or 16.0...