Shop

This part is a PVC Tee, 2"s x 2"s x 1"s.. You can make your connection back to the small side using the below kits..  Connect kit for 1" Soft pipe Click Here.. 1" Connect Kit Connect Kit for 1/2" or 3/4" Soft Pipe Click Here: 1/2" or 3/4" Connect...

This part is a Jumper Strap Set of (2) Kit to connect the heater to the circuit board on Balboa LE and Value Systems. Measures 1-3/8" x 13/16" Circuit Board Application    Balboa Water GroupCircuit Board Model    LE, Value...

Temperature Sensor This sensor is used primarily in the Jacuzzi J-Series, however it was also used in the Sundance 1998+ 701, 724, 2005 780/850E, 2006+ 780/680 systems as well. This is the curly finger style that usually found in a 4 wire connector... If...

You are Buying a 3 3/4" Wide 2"slip x 2"slip x 2"slip Hydro-Air Notched Spa Diverter Complete Assembly Gray Valve. We also offer a similar Diverter in a Kit which Includes the Diverter Valve, (3) 2" Couplers, (3) 6"...

This is a White Air Injector Jet and Body. it is a  Top Flow Type and receives a 3/8" Inside Diameter Tube, it features a 3/8" Outside Diameter 90° Ell Barb and is a Salt & Pepper Style... The hole size in the hot tub shell is 1 3/16" and...

This item is a Gray Notched Replacement Diverter Cap for a 1" Waterfall or Neck Jet Control.. The inside thread measurement is about 1 5/8" and the center hole is about 3/4".. It uses (2) Small o-rings and one O-Ring Gasket that measures...

Fuse Holder

Vico, Ultimax Pump ImpellerClosed face impeller made for the Ultimax spa pump by Vico. Rated at 3.0hp,which would be 8-10.0 Amps.. it is used in an Ultimax pump wet end, and must be installed on a 2.0hp (or greater) thru bolt motor.  Click here for...

Enclosed Circuit Board RelayCoil contacts are on bottom of relay at PC board. Trace saver tabs are available at top of relay ActionCoilAmps SPST-NO 12 VDC 30amp Coil Voltage Type    DCRelay/Contactor Style  ...

You are purchasing a Balboa Board Fuse Repair Jumper for board soldered on fuses found on many Balboa Brand Spa Hot Tub Boards. This jumper features a fuse holder with a .5A replaceable Fuse that can be added to any soldered on board fuse that has been...

Waterway PlasticButton style single hole air injector with 5/16" barb fitting. 3/8" hole required for installation