PVC Plumbing Fittings

This part is a Trough Filler Water Nozzle Wall Fitting featuring a 3/8" Barb that is used in a Waters Edge Hot Tub to fill the waterfall spill over..  Note: This Part is Graphite Gray. Other Brands might be Dr Wellness    

This Kit consists of 4" of 3/4" Inside Diameter Clear Tubing, (2) Clamps and (2) 1" Street x 3/4" Barb Couplers.. This Kit is used to connect your 3/4" pipe connection that is being replaced to a more modern outside barb type seal... You achieve the 3/4"...

This Kit is a Barb Coupler, Glue, Tubing and Clamps..   3/4" smooth Barb x 3/4" Smooth Barb with 6" of 3/4"ID Tubing and (2) 3/4" Roto Clamps used to extend a 3/4" tube to Barb connection..

This Kit is a Barb Coupler, Tubing and Clamps..  , 3/4" Smooth Barb x 3/4" Smooth Barb with 6" of 3/4"ID Tubing and (2) 3/4" Roto Clamps used to extend a 3/4" tube to Barb connection..

This is the shortest Coupler or Coupling, 2" Slip x 2" Slip, Short measures 1 5/8" and is about 1 1/4" shorter than the normal coupling and 3/4" shorter than the middle size.. Note: This Coupler does not have as much surface for gluing so it will not...

This kit is a 3' Long RADKit® designed to go onto the outside of a 2" fitting and seal off the area between (2) 2" Fittings Outside to Outside.. An example would be if you had a Suction fitting dripping at the glue joint and there is a piece of 2"...

This part is a Hot Tub Replacement Bottom Drain Inside Wall Fitting with a 3/4" slip fitting on each end which measures about 1" I.D.. This part is on the foam side of the tub and the Fitting screws into this fitting.. You have to stand the hot tub up...

This part is a (1) 90 Ell 1 1/2" Street X 1 1/2"Slip with an 1/8" FPT hole in the side.. The 90 ELL receives a 1 1/2" fitting on one side which would measure 1 7/8" OD and then slips into a 1 1/2" fitting on the other side that would measure 1 7/8" ID on...

This part is a 2" Slip x 2" Street 90 Elbow w/thermowell fitting, 5/16" t-well, 90° ell pvc... The 2" fitting measure about 2 3/8" ID on the slip side and 2 3/8" OD on the street side..   PVC Pipe Fitting Type Ell, 90 deg w/t-well Heater...

The part is a 1" x 3/4" - 3/4" Wye.. Manifold Wye

This part is no longer available.. But we have a solution.. The Kit is a 1" x 3/4" - 3/4" Wye with reducer bushings 1" to 3/4" and 3/4" to 1/2".. These bushings also make it easier to Spin It to Win It. Manifold Wye

This Kit is a 3/4" Spin To Win Glue Kit for 3/4" Plumbing repairs where you are connecting old 3/4" Plumbing that measures about 1" OD to new plumbing.. The kit includes a 6" Piece of 3/4" Flex Pipe that measures about 1" OD and a 3/4" Coupler and (1)...