Shop

This part is a Temperature and Hi-Limit Sensor that fits some ACC control systems the cable is 20" long and the sensor bulb is 1/4" Diameter and it uses a 2-pin connector.. Fits ACC Smartouch and Epack control systems regardless of year.

This part is a Used New Style 3 Lug Terminal Block found on many Balboa Brand Spa Hot Tub Boards. This terminal Block can get burned on one or two legs and if the soldered on finger terminals are good on the board you can replace this part and not buy a...

This Seal Kit with bearing is used ONLY in Watkins HotSpring Caldera Wet Ends where the motor has the Vendor code of 3536. This kit features the seal, (1) bearing and an install tool as well as silicone to install the seal with.. It is 1 39/64" Across...

This Seal Kit is used ONLY in Watkins Hot Spring Caldera Wet Ends where the motor has the Vendor code of 3536. This kit features the seal and an install tool as well as silicone to install the seal with.. It is 1 39/64" Across the back of the Spring...

This Seal Set is used ONLY in Watkins HotSpring Caldera Wet Ends where the motor has the Vendor code of 3536. It is 1 39/64" Across the back of the Spring Seal part that goes into the volute or wetend back and the Ceramic & Rubber part that goes...

This Kit Fits Watkins, Vendor #4081, Wavemaster Pumps found under the name Wavemaster 6000, 7000, 8000, 8200, 9000, 9200 numbers Features (2) Bearings & (1) Seal for 4081 Pumps on Hotspring Watkins Hot Tubs and (1) 1/2Oz Tube of The Professor's Silly...

This is a Set of (3) barb plugs used to plug off a 3/8" port on Air manifolds or Air Sides of Jet Bodies that are above the water line of the tub. We offer many different plugs based on the brand of manifold.

This part is a Manifold that features (6) 3/8" Barbs and is Flow Thru, 1-1/2"slip x 1-1/2"spigot.. To plug the barbs you can use these plugs: Barb Plug 3/8" Slip for Air Manifold and more Waterway Set of (3) Barb Plugs 3/8" Slip for Air Manifold and...

This is a Kit that features (1) PS-200 Seal and (2) Bearings that fit most motors that are mated to Aqua-Flo Pump Wet Ends as well as Waterway " Viper" Wet Ends, The Professor silly Juice to seal the seal. This Seal is used in Most Aqua-Flo Wet Ends...

This kit is a Kit that Fits Watkins, Vendor #4081, Wavemaster XP2 Pumps found under the name Wavemaster 6000, 7000, 8000, 8200, 9000, 9200 numbers Features (1) Seal for XP2 Pumps on Hotspring Watkins Hot Tubs and (1) 1/2Oz Tube of The Professor's Silly...

This part is a Pressure Switch Cable that is 7" long and Universal for use on most SSPA, MSPA, T-MSPA, and some Hydroquip boards..

This part is a Master Spa 8 Button Overlay for Master Spa Legend Series 2005-2012 Topside for a Three Pumps with Light. This Overlay can be used to replace your original Overlay with your brand on it as long as the button configuration works out. ...