Shop

This kit is a Kit that Fits Watkins, Vendor #4081, Wavemaster XP2 Pumps found under the name Wavemaster 6000, 7000, 8000, 8200, 9000, 9200 numbers Features (1) Seal for XP2 Pumps on Hotspring Watkins Hot Tubs and (1) 1/2Oz Tube of The Professor's Silly...

This part is a Pressure Switch Cable that is 7" long and Universal for use on most SSPA, MSPA, T-MSPA, and some Hydroquip boards..

This part is a Master Spa 8 Button Overlay for Master Spa Legend Series 2005-2012 Topside for a Three Pumps with Light. This Overlay can be used to replace your original Overlay with your brand on it as long as the button configuration works out. ...

This Item is a Board Fuse .05Amp Slo Blo MDA Style Ceramic Fuse that measures 1 1/8" Long x 1/4" Wide and is used on some Hot Tub or Pool Boards. This is a smaller automotive style fuse that does not have glass but used ceramic to dissipate heat. You...

This part is a 3 Wire Thermostat replacement found in some Air Button Topsides that require 3 wires to operate.. Single pole rated at 25 amps with max temp rating at 107°F. Best results are obtained when the bulb is installed in a dry well or groove...

This part is a Balboa 6 Button Overlay for a Topside for a Two Pump with Light System. This Overlay can be used to replace your original Overlay with your brand on it as long as the button configuration works out. On the overlay starting at the left of...

This kit is a New Style Jacuzzi® Premium or Sundance Spa Diverter (3) Piece O-Ring Kit only. This Diverter O-Ring Kit Features (1) Small O-Ring that fit on the Stem sealing the inside of the cap and (1) Medium Size O-Ring that fits on a disc...

This kit is a Repair kit for a 2007+ 4" Wide Capped JACUZZI® Premium J Series 300 and some 400 Model Spa Diverter Valves. This Kit comes with The Cap, Handle, Stem Gate Valve, (2) Small O-Rings and (1) Large O-Ring. The Valve...

This Kit is a 45° 2" Pump Union To Plumbing Glue Connect Kit found in many Dynasty Brand Hot Tubs. The Pump Union which measures about 3" Inside the threads glues into a 2" Slip X Slip 45° fitting on one side and then a 2" Slice Valve Glues...

This Kit is a 45° 2" Pump Union To Plumbing Connect Kit found in many Dynasty Brand Hot Tubs. The Pump Union which measures about 3" Inside the threads glues into a 2" Slip X Slip 45° fitting on one side and then a 2" Slice Valve Glues...

This O-ring is used on some 1 1/2" Pump Union that measures 2 1/8" Center to Center of the o-ring groove.. Part Type    O-RingJet Part Type    Gasket/O-RingCross Section    1/8"Union Fitting...

This Kit is a Universal Air Bleeder Connect Kit with (1) 1/4" Mpt X 3/8" Barb Plug, (1) 3/8" x 3/8" Barb Coupler, (4") of 3/8" Clear Tubing and Silicon sealer usually used on Hot Tub Pump Faces to bleed the air off the pump while filling the tub up. I...