Shop

Vico Ultimax Pump ImpellerClosed face impeller made for the Ultimax spa pump by Vico. Rated at 1.5hp,which would be 8-9.0 Amps.. it is used in an Ultimax pump wet end, and must be installed on a 1.5hp (or greater) thru bolt motor.  Click here for...

This part is a Slice, Gate Valve, Waterway, 2-1/2" Slip x 2-1/2" Spigot, Coast Spas and Others... The OD of the Street Spigot side measures about 2 7/8" and the ID of the Slip side measures about 2 7/8"..   This is a very unusual valve and an odd...

This part is no longer available.. This part is a 5 pin Male side Amp connector 20 Amp . This part is normally found on the Cord side that would come from a pump or blower or other accessory. Note: You will need a pin tool to replace this part to...

This part is a 5 pin female side Amp connector 20 Amp . This part is normally found on the control pack side mounted for the male amp cord that would come from a pump or blower or other accessory. Note: You will need a pin tool to replace this part to...

This part is the Control Box Board Side Female AMP Connector that houses (2) Female Pins.. The Pins are not included.. This connector is used often on light cables.. Terminal Type AMP Terminal Style AMP Plug Housing Female Number of Connections 2 ...

This part is a 2.5HP Impeller that fits some Piranha Wet Ends found on Sundance, Jacuzzi and other brand Hot Tubs.. Click Here for Seal and Other Part options for this impeller: (8) Mount Parts Impeller Type Closed Face Impeller Diameter OD 4-1/4" ...

This part is an Overlay for a IN.XE K-200 Topside that features 4 buttons (2) pump, (1) Light, Temp.. The dimensions of the topside it fits is Dimensions 2" x 4-3/4"... For the One Pump Version Complete Topside Click here: Topside, Aeware, In.k200, 4...

This part is an Overlay for a IN.XE K-200 Topside that features 4 buttons (1) pump, (1) Light, Temp Up and Down.. The dimensions of the topside it fits is Dimensions 2" x 4-3/4"... For this Complete Topside Click here: Topside, Aeware, In.k200, 4...

This part is an Adapter Kit to convert the new style sensor set for Watkins No-Fault 4000 or 6000 heaters to the old style plugs.. Includes: The Two Adapters only for the Sensors click the link below: Below is a list of related parts click on the links...

You are purchasing a 3 Terminal Power Block found on many Control pack and board set ups..

This part is a Tee used in conjunction with a Micro Jet Body for the water connection that glues inside of the back of the Micro Jet Body and it is 3/4" Barb X 3/4" Barb Connection for the hose...  Below is a list of the parts related to this part....

This part is a 90 degree Barb used in conjunction with a Micro Jet Body for the water connection that is 3/4" Barb and Glues inside of the Bullet Jet Body...  Below is a list of the parts related to this part.. Bullet Jet Body, G & G, Micro...