Shop

This part is an Aqua-Flo XP3 Pump 2.5HP Impeller exclusively for an Aqua-Flo XP3 pump which has 2 1/2" inlet and outlet which measures about 3 9/16" across the threads...I have found this 2.5HP pump impeller to be on a 10-12amp motor... Click here for...

This Leisure Bay, Rec Warehouse Filter Cartridge is 17 3/4" tall and 5 5/16" wide.. It has a hole in the center of the top and bottom that measures 2 1/8"...   Diameter    5-5/16"Length    17-3/4"Top Style  ...

This part is a Set of Jumper Wires that would go from a standard heater element Electrode Tab to the board bolts.. These can be used on 4.0kw to 5.5kw elements.. Circuit Board Application    Balboa Water GroupManufacturers Part...

"Magicmend" Pipe extenderSimply cut the bad fitting and remove it from the system. Glue the correct size Magicmend into place and replumb your new fitting  

This part is a Wear Ring that only fits Guangdong LX or LP Impellers for a 48 or 56 Frame Pump Wet Ends and measures 3/4" thick from front to back... WUA Pumps.. Note: When Replacing some original LX Pump faces the wear ring was built into the face....

We no longer have the Tear Drop Style air control but we have the new style replacement here: Air Control Valve Cal Spa Swoosh Style 1" Spa Hot Tub This Part is a  Cal Spa 1" Spa Hot Tub Air Valve " Cap Only". The Valve Tear Drop Cap Width is approx...

This O-Ring is a replacement for the Square Gasket that is found in the Sundance, Jacuzzi, Thera-Max, Thera-Flo, 2" Flat Style O-Ring..  Heater Union Part Type    O-RingPart Type    O-RingO Reference Number  ...

You are buying a Cal Spa 7000 or 9000 Heater M7 foam type Sensor. This Sensor comes with the wire, Connector, and The foam sensor. It DOES NOT include the tube, the tube side mount or the pull ties. When this sensor is bad it will generally cause a SN...

This part is a Sundance or Jacuzzi Hi Limit with the smaller bulb for 400, 600, 600-S, 750, 95+ with Bypass Heater...

This part is a Volute O-Ring, 5" ID, 3/32" Thick, Vico Ultima Series, 48 or 56 Frame...

You are buying a Pressure Switch RP2100 with Plastic Header that fits a Raypak Gas Heater System, 105B, 185, 130A, 207A, R185A, 1.75psi..  PRESSURE SWITCH IS A BARKSDALE (THE LITTLE GENERAL) SWITCH # MSPS-EE05-Q71 .5-5.0 PSI (8 MAX) MAX...

You are buying on a 2" Slip X 2" Barb Adapter.. This adapter glues inside of a 2" PVC plumbing fitting and a 2" Inside Diameter Tube glues onto the barb..  This part is found in Strong Spas and some others I will list them as I find out...