Shop

This Part is a White 2 5/8" Face Width Replacement Knob for Waterway, Hydro-Air or CMP Brand Waterfall Control Valves.. The Bottom Accepts a 5/8" wide Square Stem and we offer these in Black, Gray and White.. See the link below..  Knob,...

This item is a White Notched Replacement Diverter Cap for a 1" Waterfall or Neck Jet Control.. The inside thread measurement is about 1 5/8" and the center hole is about 3/4".. It uses (2) Small o-rings and one O-Ring Gasket that measures...

This 1" Waterfall Control Plunger Replacement Kit is found in some 1" Waterfall or Neck Jet Control valves. This kit features the plunger and stem, The Gasket for the bottom of the plunger and clip that holds the stem inside the cap and an o-ring kit for...

This part is a Jet body that is used with HydroAir Fixed 1 1/2" Wide Face Bullet or Ozone Style Jets...Rated at 3-4 gpm and requires a 3/4" hole in the shell.. The pipe connection is 1/2" which measures about 3/4" OD... For Jet Faces used with this body...

This item is a Black Notched Replacement Diverter Cap & O-Ring Kit for a 1" Waterfall or Neck Jet Control.. The inside thread measurement is about 1 5/8" and the center hole is about 3/4".. It uses (2) Small o-rings and one O-Ring Gasket...

This item is a Gray Notched Replacement Diverter Cap & O-Ring Kit for a 1" Waterfall or Neck Jet Control.. The inside thread measurement is about 1 5/8" and the center hole is about 3/4".. It uses (2) Small o-rings and one O-Ring...

This item is a Replacement Diverter Cap and O-ring Kit for a 1" Waterfall or Neck Jet Control.. The inside thread measurement is about 1 5/8" and the center hole is about 3/4".. It uses (2) Small o-rings and one O-Ring Gasket that measures about 1 1/2"...

This part is a Starter Capacitor that fits many 115V and 230V Pump Motors. When diagnosing pumps for a no start condition where it is powered up but just hums you can hand spin start the motor by taking a screw driver to the shaft in the back and...