Shop

Temp/Hi Limit Sensor Assembly

This Filter is used in a Sundance Filter where this part slides onto a plastic cage that is screwed to the end of a filter and placed into the filter housing of a Sundance brand hot tub only..    Diameter 7-3/4" Length...

Manifold/Barb Fitting

Waterway Hi-Flo Pump ImpellerClosed face impeller made for the HiFlo side discharge pump by Waterway Plastics. Rated at 1.5hp, it is used in a Waterway Hi-Flo pump wet end, and must be installed on a 1.5hp (or greater) thru bolt motor. Shaft seal...

This kit is a (30) piece Clamp Kit that fits 1" OD , 3/4" ID Clear Hose ONLY. These are used for connecting Clear Hoses to many PVC Plumbing Parts in Hot Tubs. You can put these clamps with other parts we are offering in our store to make...

This part is a Manifold, 1/2" Slip, 6 Port, Transition, 2" Slip Barb/Port Size 1/2" Number of Ports 6 Manifold Fitting Type Transition Manifold Plumbing Size "A" 2" Manifold Plumbing Type "A" Slip (s)

ThermostatsSingle pole rated at 25 amps with max temp rating at 107°F. Best results are obtained when the bulb is installed in a dry well or groove tube at or immediately before the heater. This is a safety device! If it is found to be out of...

This impeller fits a Universal CMP Brand 3HP Wet End only and it requires a Special Seal that you will find a link to below.. This impeller may also have any of the following manufacturer part numbers stamped on the back: 27203-300-300, 27203-000-300, or...

This filter Fits some Dimension One and At Home Hot Tubs after 2000.. It is 10 1/2" Ta x 7 1/8" Wide has a closed top with castle tabs and features a butterfly type twist lock bottom where you slide it down over the butterfly hole in the filter housing...

This item is a Rising Dragon Brand LED Single Light Lens... Light Wall Fitting, RD, Mini POL, 1/2" Hole Size, 11/16" Face Diameter, Clear, Lens, Point of Light With the Rising Dragon Pinnacle Light System, there is no complicated cabling or hub layouts...