Shop

This part is an Aqua-Flo XP2 Impeller for a 2.5HP Motor which would have an Amperage Rating of about 11.0Amps on High Speed at 230V and is Not Applicable for 115V Pumps... It will also be a 56Frame motor which would have a 5/16" head on the through...

This filter fits Jacuzzi Premium Hot Tubs J-300, J-400 Series. It is 15 1/2" Tall and 6 5/8" Around and Features a 2" SAE which is a Thick Thread and measures a hair less than 2" Inside diameter and measures 2 3/8" to the outside of the threads. There...

This Kit is an 2HP Impeller for an Executive 48 Frame Wet End up to 2HP Motor and a 56 Frame Wet End 2 HP Motor. This Impeller fits between the Face and the Volute of an Executive Wet End. I would advise replacing the Seal when you...

This part is a G&G Suction cover that measures about 4 7/8" edge to edge.. It has a single hole in the center and comes with a stainless screw to hold it into place..Cover Diameter    4-7/8"Suction Fitting Part Type  ...

This is a 2HP Impeller for an Aqua-Flo 48 Frame Side or Center Discharge FMHP, FMCP, FMVP, and TMCP Series Wet End 2HP Motor that has about 10.0 Amps on High Speed. This Impeller fits between the Face and the Volute of an Aqua-Flo FMHP, FMCP, FMVP, and...

This part is an Amp Style Male Pin crimp connector that fits wire that is 14-20 Gage and is usually found on the pump or other accessory side plug connector that is mounted on the cable.. This listing is 25 Pins..   Terminal Type AMP Terminal...

Start Capacitor1-7/16"dia x 2-3/4"hgt

You are buying a 4.0KW Chemical Resistant DuPont Teflon® Coated Flow Thru Heater Element for 230V or 115V Applications that features the bend in the back of the element needed to fit the Balboa M-7 heater tubes. This also fits Gecko, ACC, and most...

"Magicmend" Insider Connector - Fits inside of 1" pipe which would meausre 1" Inside Diameter and 1 1/4" Outside Diameter.  Why use an additional fitting when you can use a MagicMend® Insider Connector? The MagicMend® Insider Connector will...

Waterway PlasticButton style single hole air injector with 5/16" barb fitting. 3/8" hole required for installation   Hole Size 3/8" Face Diameter 3/4" Manufacturer Waterway First Plumbing Connection Size 1/4" First Plumbing Connection...