Shop

SC Series Time Delay FuseIdeal for protection of loads subject to high short circuit currents. Protection to 60 amps

This part is the Cord Side Male AMP Connector that houses (3) Male Pins.. The Pins are not included..   Terminal Type AMP Terminal Style AMP Plug Housing Male Number of Connections 3 Terminal Amperage 20A The other parts related to this...

ThermostatsSingle pole rated at 25 amps with max temp rating at 107°F. Best results are obtained when the bulb is installed in a dry well or groove tube at or immediately before the heater. This is a safety device! If it is found to be out of...

This Part is a Surface Mount Style HI LIMIT: Single Pole Single Throw THERMAL FUSE Auto Reset (With NO CAPILLARY)This Hi Limit Surface mount surface mounts to the heater in a spot where it can read what the actual water temperature is flowing through the...

This item is a Suction Return Assembly, Waterway, 3-3/4",  Hi-Flow, 2-3/8" hole size, 1-1/2" slip, Gray, w/o Vacuum Break .. It is VGB Certified 

This part is a replacement wear ring found in 48 frame 1 1/2" Flo-Master "FMHP" Series Side Discharge and "FMCP" Center Discharge Spa Pumps.. The ring measures about 1 3/4" inside the wear ring and 2 3/16" at the widest part and about 3/4" tall.. ...

Vico Ultima, Ultra Flo Pump Impeller for a 2HP Motor which would have an Amperage of around 10 Amps on High Speed... Closed face impeller made for the Ultima and Ultra Flo spa pumps by Vico. Rated at 2.0hp, it is used in an Ultima and/or Ultra Flo pump...

This Wear Ring only fits Waterway Executive 1, 2, or 3HP Impellers for a 48 or 56 Frame Pump Wet Ends and measures 1-1/16" thick from front to back... If you have a Waterway Executive 4 or 5 Horsepower Wet End it will require a different wear ring that...

Tinytrol™ Air SensorProvide the same powerful switching action in a small package as found in larger air switches. Available in single pole or a very sensitive patented double pole designDPDT21 ampLatching9/16" thd

This part is an Amp Style Female Pin crimp connector that fits wire that is 14-20 Gage and is usually found on the pack or board side plug connector that is mounted on the board housing.. This listing is 25 Pins..   Terminal Type AMP Terminal...