Shop

This part is a Pump Face for a Vico Ultima Side Discharge wet end that is 2" which measures about 3" edge to edge across the threads.. The Seal Kits for this pump can be found here: Vico Seals 201 The other parts for this pump can be found here: Ultima...

This part is a Complete FMHP 1.0HP Aqua-Flo 1 1/2" x 1 1/2" (Which measures about 2 3/8" Across the Threads) Side discharge 48 frame wet end for FMHP pumps. This wet end is used with a 48 frame motor that would have about 8.0 Amps on High Speed on a 230V...

Manifold/Barb Fitting

You are buying a 1" FTB X 3/4" Barb Pump Union with O-ring that matches the Union.The Union receives a 3/4" Inside Diameter Hose which measures about 1" on the outside and then Screws to a 1" Wetend (Pump) Threaded Part on the other side the threads will...

T90 Style Circuit Board RelayCircuit board mounted, available in various coil voltages. Use to complete simple circuit board repairActionCoilAmpsSPST12 VDC30amp

This part is an Air Injector, Galaxy, Stainless, 3/8" barb, Garden Tub...  Hole Size    5/8"Face Diameter    1-5/8"Manufacturer    Custom Molded ProductsColor    Stainless

This part is a 2.5HP Sta-Rite DJ Dura-Jet Pump Impeller.. This impeller will usually have the number 17400-0123 cast into the back and will measure about 3 3/4" wide with an eye width of 1 3/4" and a vane width of 1/2".. This can be found on motors with...

120 Wye, 2" Slip x 2" Slip x 2" Slip     Each of these Slip Fittings accept a 2" Pipe or fitting that would measure about 2 3/8" Outside Diameter.. (PVC) Plastic Pipe Fittings, Sch 40.   PVC Pipe Fitting Type Wye, 120 deg ...

This is a Thermcore Plastic replacement sleeve. The Stainless Steel version is no longer available.. Sensing Bulb Size 5/16" Depth 4" Plumbing Connection Size "A" 1/2" Plumbing Connection Type "A" Male Pipe Thread (mpt)

No longer available in the 48" length. We do have a 36" that may work in your model here: Thermostat, Invensys, 1/4", 36", SPST, 25A Single pole thermostat rated at 25 amps with max temp rating at 107°F. Best results are obtained when the bulb is...