Shop

This part is no longer available in Gray.. We do offer it in Black here: Basket, Skimmer, OEM Waterway Dyna-Flo T/M Low Profile, Black This item is a Waterway Top load style filter basket in Gray see specs below for sizing..      Basket...

This part is a Spa Drain and Fill Valve, Waterway, 1-5/8" ACME Thread x 1" Slip Black 1-3/8" Hole size.. Drain Valve Complete    Drain Valve AssemblyHole Size    1", 1-3/8"Hole Size Fitting Type    ACME...

This part is a Rubber Pump Motor Base Vibration Dampener for 48 and 56 frame pumps. Includes 4 soft 'washers' to isolate mounting screws from touching the motor base. This motor base mounting pad fits under any 48 frame pumps, and under most 56...

This item is a 3/4HP Waterway HiFlo Pump Impeller "B".. If Your motor is 115V the amperage would be about 11 Amp if 230V it would be about 7 amps..Closed face impeller made for the Hi-Flo side discharge pump by Waterway Plastics. Rated at...

Top Draw Air ControlAvailable in 1" or 1/2 " modelsHole size 1-3/4"

 Vico Ultima Ultra Flo or Ultra Jet Pump ImpellerClosed face impeller made for the Ultima and Ultra Flo spa pumps by Vico. Rated at 4.0hp,which is between 12 and 14 Amps.. it is used in an Ultima, Ultra Jet and/or Ultra Flo pump wet end, and must be...

This item is a 1/8" MPT Brass Plug which can be used to block an 1/8" MPT (male Pipe Thread) hole normally found on a Heater Tube on Hot Tubs. This hole size is the same size as a Pressure Switch hole and would measure about 3/8" wide across the hole or...

This part is an Aqua-Flo XP2 Impeller for a 2.0HP Motor which would have an Amperage Rating of about 10.0Amps on High Speed at 230V and 16.0 Amps on High Speed at 115V... It will also be a 56Frame motor which would have a 5/16" head on the through bolts...

The "Smart" Check is equipped with a 1/2Ó lb spring-loaded gate mechanism, allowing the valve to be installed in virtually any orientation.

THis part is no longer available..