Shop

Stainless steel aftermarket replacement heater assembly that fits systems that use dual sensor technology. 2" x 15" with two thd taps for the sensor assembly rated at 5.5kW/240v. Replacement sensors sold separately.

This pump is a Waterway Genesis Generation Energy Efficient Bath Pump 7.5 amps 115 Volts w/Air Switch The Plumbing connections are 1 1/2" on the Pressure and Suction sides which measure about 2 3/8" across the threads.. There are two barbed fittings on...

This item is a 48 Frame Vico Wet End with 2" x 2" inlet and outlet that would measure about 3" across the threads and it has a 4.0HP impeller which would fit a motor that has 12.0-14.0 amps at 230V and there are no 115V motors this fits.. Pump to Motor...

This part is a complete Heater, Flo Thru, Balboa M7, 800, 825, 15" x 2", 230v or 115v , 4.0kW, with Sensors..  This heater tube has a stud on the top and bottom make sure yours has them too.. This heater DOES include m7 sensors and split nuts, but...

This part is aflow-thru style is used on the 2006-forward Solana TX (triangle spa), RX (round) & SX (square) as well as the 2006-forward Hot Spot models except the Sprint and Dash. 15” length 4.0kWgrounding and mounting studsTemp Sensor or High...

Heater, FloThru, Watkins TR, 15" x 2", 4.0kW, 230v, Generic Note: This heater does not have a Pressure Switch port or studs for the ground bar..   Housing Configuration    StraightHeater Length    15"Lead End Terminal...

This Part is a Retrofit Heater tube to replace the original Cal Spa, Emerald of Polynesian 15 3/4" x 1 1/2" Heater and tube.. includes Tube, Element, Split nuts and Gaskets along with the 1 1/2" to 2" conversion fittings. This generic hot tub heater is...

  This Complete Wet End fits a 1019801-03 Vendor Code 3536 2 HP 56 Frame Pump.. It is about 7 1/4"" across the face of the pump, it measures about 7 3/8" from the bottom to the top of the pressure side of the volute, it also...

This part is a 15" Heater Tube with a 4.0KW Heater in it that is found in some Sundance 680 Series tubs and some Sweetwater & Del Sol tubs as well with a High Flow .. For other parts related to this heater Click the links: Pressure Switch 1/8" mpt 1...

This part is a 15" Heater Tube with a 5.5KW Heater in it that is found in some Sundance680 Series Tubs and some Sweetwater tubs as well with a High Flow .. For other parts related to this heater Click the links: Pressure Switch 1/8" mpt 1 Amp Hot Tub Spa...

Waterway Hi-Flo Wet EndSide discharge, 2"mbt suction/discharge, 48 frame wet end for the Waterway Hi-Flo pump. This wet end is used with a 1.0hp, 48 frame, thru-bolt style motor. The motor used may be either a single or dual speed. The wet end may be...

This part is a Ozonator, JED, Corona Discharge, 230V, w/4 Pin Amp Cord JED 103-DescriptionThe JED103 is a CD or "corona discharge" type ozone generator designed for water purification in residential or commercial hot tubs, swim spas, fountains and lap...