Shop

This 2.5HP Impeller fits a Jacuzzi Piranha 4 Stand Wet End Fixed Bracket Motor only and would be found on a motor that is about 11.0 Amps on a 230V motor..... It can be found under the Name Thera-Max or Thera-Flo on Sundance tubs and is also on Jacuzzi...

This filter is 13 1/2" X 4 15/16" and has a female SAE Large Thick Thread that is 2" which would really measure about 2 1/4-2 3/8" ID. This filter is found in Dynasty Bahama Tubs and others. If you have the shorter version of this filter which is 9 1/4"...

This part is a Trough Filler Water Nozzle Wall Fitting featuring a 3/8" Barb that is used in a Waters Edge Hot Tub to fill the waterfall spill over..  Note: This Part is Graphite Gray. Other Brands might be Dr Wellness    

Brass Fitting that fits an 1/8" MPT Jacuzzi heater fitting on one side a 3/8" ID tube on the other side. I have seen these in Jacuzzi Premium Trombone Heaters to attach the heater to the bleeder system though there are many applications this can be used...

Waterway NEO 2100 ETS Hi-Limit Sensor.   Spa Control Sensor Type Hi Limit Application Waterway Model ETS Connector Type 2 pin Wire Count 2 wire

Waterway NEO 2100 ETS (Electronic Thermal Sensing) Temperature Sensor. Similar to Balboa's M7™ Technology, the NEO 2100 uses (2) ETS sensors to determine the water temperature.     Sensor Application Spa Control Sensor Type...

This topside is the large version of the E4 topside.. from left to right is Jet, Jet, Temp then Light.. The type is MVP260, VL260 and others.. This is an ideal replacement for Viking Brand Hot Tubs and has a 7' cord so if you need it to work on the...

This part is a Used cover Face Plate 56 Frame A.O. Smith Motor.... Note: This is a used part because there are no new offered without the complete motor and the condition will vary although we will not send you a cover that is not useable..

This Kit consists of 4" of 3/4" Inside Diameter Clear Tubing, (2) Clamps and (2) 1" Street x 3/4" Barb Couplers.. This Kit is used to connect your 3/4" pipe connection that is being replaced to a more modern outside barb type seal... You achieve the 3/4"...

This Kit fits a 1019801-03 Vendor Code 3536 Watkins 2 HP Pump and Includes an Impeller, Seal, Bearing, Silicon and Seal Installation Tool... It is about 4 1/8"" across the face edge to edge, it measures about 3" from the tip of the front to...

This part is a Pump Bleeder Barb for some Watkins Wavemaster XP2, XP2E, LX and others.. It is 1/4" Barb x 1/4"Mpt and is used with an unusual bleeder line.. The line is 1/4" Inside Diameter not 3/8" Inside Diameter like most bleeder lines.. This...

This Watkins 1019801-03, 0977601-03 or 39577-03, Vendor Code 3536 2HP Impeller, Seal, Silicon and Seal Installation Tool that fits 56 Frame Pump Wet Ends manufactured by Intertek LX Brand only. It is about 4 1/8"" across the face...