Shop

The lens is a replacement for the retro kit light lens. This Replacement Lens is for the following models. Make Model Date Range Hot Spring Grandee 2000-Current Hot Spring Vista 2004-2013 Hot Spring Envoy 2004-Current Hot Spring Vanguard 2001-Current...

This filter fits Jacuzzi Premium Hot Tubs J-300, J-400 Series. It is 15 1/2" Tall and 6 5/8" Around and Features a 2" SAE which is a Thick Thread and measures a hair less than 2" Inside diameter and measures 2 3/8" to the outside of the threads. There...

This Kit is a Set of (9) Replacement Gaskets Only (3) Gasket for the "A" Coupling and (6) for the "B/C" Couplings.. The "A" Gasket measures about 1 7/8" edge to edge overall and the lip or L shaped part measures about 1 9/16" Center to Center.. The...

This Kit is a Set of (6) Replacement Gaskets Only (2) Gasket for the "A" Coupling and (4) for the "B/C" Couplings.. The "A" Gasket measures about 1 7/8" edge to edge overall and the lip or L shaped part measures about 1 9/16" Center to Center.. The...

This Kit is a Set of (3) Replacement Gaskets Only (1) Gasket for the "A" Coupling and (2) for the "B/C" Couplings.. The "A" Gasket measures about 1 7/8" edge to edge overall and the lip or L shaped part measures about 1 9/16" Center to Center.. The...

This part is a Magic Plastics Drain Valve that mounts through the side wall with a removable front nut to release it from the side panel.. It features a 3/4" Barb and measures about 7" Long overall.. Drain Valve Complete Drain Valve Assembly Hole...

This part is a Waterway 1" Spa Hot Tub Air Control Valve with the hidden type cap to be used under a larger handle style cap. You use this valve to replace the guts of an installed valve and don't use the body.. The Valve Cap Width is approx. 2 11/16".....

This part is (1) Complete Threaded Coupler that is 2" Slip X 2"Slip. The Coupler receives a 2" fitting which measures 2 3/8" OD on one side and then receives a 2" fitting which measures 2 3/8" OD on the other side. The inside diameter...

This is the shortest Coupler or Coupling, 2" Slip x 2" Slip, Short measures 1 5/8" and is about 1 1/4" shorter than the normal coupling and 3/4" shorter than the middle size.. Note: This Coupler does not have as much surface for gluing so it will not...

This kit is a 3' Long RADKit® designed to go onto the outside of a 2" fitting and seal off the area between (2) 2" Fittings Outside to Outside.. An example would be if you had a Suction fitting dripping at the glue joint and there is a piece of 2"...

This is a XP2 1.5HP Seal & Impeller with a 2 1/8" Eye Width and a 5/16" Vane Width and 4" OD for an Aqua-Flo 48 or 56 Frame Wet End 1.5HP Motor that has about 9.0 Amps at 230V. This Impeller fits between the Face and the Volute of an...

This part is a Hot Tub Replacement Bottom Drain Inside Wall Fitting with a 3/4" slip fitting on each end which measures about 1" I.D.. This part is on the foam side of the tub and the Fitting screws into this fitting.. You have to stand the hot tub up...