Pumps and Related Parts

This kit is a Set of (2) Air Bleeder barbed plugs and Silicon sealer usually used on a Dynasty Hot Tub with Waterway Hot Tub Pump Face to bleed the air off the pump while filling the tub up. I have seen these fittings in many brands just compare the...

This part is a Replacement "A" Coupling for Water jet spa for all some Saluspa or Lay-Z-Spa AirJet™ Hot Tub models (Siena, Miami, Havana, Paris, Palm Springs Air Jet, New York, Vegas, Saint Tropez, Hawaii and Monaco). If the "A" Coupling...

This Part is a Barbed Bleeder Barb with O-Ring that fits New Style 48 or 56 Frame WUA Intertek LX Brand Pump Wet End that uses a fine thread bleeder plug.. Watch the video for instruction on how to install this part and also how to...

This part is a Complete CMHP 1/15th HP Aqua-Flo 1 1/2" x 1 1/2" (Which measures about 2 3/8" Across the Threads) Side discharge 48 frame wet end for CMHP pumps. This wet end is used with a 48 frame motor that would have about .6 Amps on High Speed on a...

This Parts is a NON-Standard 2" Heater or Pump Union O-Ring that measures 2 5/8" Center to Center. The O-Ring is 2 5/8" center to center and fits some unions but most unions are 2 1/2" center to center... Do not buy this O-Ring until you...

This Parts is a NON-Standard 2" Heater or Pump Union O-Ring that measures 2 5/8" Center to Center. The O-Ring is 2 5/8" center to center and fits some unions but most unions are 2 1/2" center to center... Do not buy this O-Ring until you...

This part is a Front and Back Volute for a Vico, Ultimax, 2" X 2", 48 or 56fr motor.. This part will fit both 48 and 56 frame motors and does not come with any other accessories like the seal, bolts or impeller.. For other parts click this link for this...

This part is a Volute O-Ring, 6" ID, 3/32" Thick, Vico Ultimax, 48 or 56 Frame...

This Face Plate O-Ring Is 5 1/8" Inside Diameter and is 1/8" Thick. It is found on Aqua-Flo 1 1/2" x 1 1/2" (Which Measures 2 3/8" Outside of the threads on the Sunction and Pressure Side of the Wet End) These Wet Ends used the names Flo-Master,...

This part is an O-Ring that fits a Jacuzzi® J Pump Style Pump Union Only.. This O-Ring measures about 2-3/16" Inside Diameter and about 2 1/2" Outside Diameter.. Make sure you look at the pictures of a J Pump union provided in the picture section to...

This Kit is a 3/8" Tubing Connection Kit for 3/8" Plumbing repairs where you are connecting old 3/8" Clear Tubing that measures about 1/2" OD between a cut air control line and the 3/8" Barb on an Air Manifold or Jet Body Air connection.. The kit...

NOTE: This Seal will NOT Fit Sundance® or Jacuzzi® Tubs with a LX Guangdong Wet End for those parts click here Jacuzzi® & Sundance® LX Parts This Swim Spa Pump part is a Swim 56 Seal Kit that includes the...