Dynasty Hot Tub Parts

This part is a Kit which includes (2) 2" which measure about 3" ID Heater Split Nuts, (4) Screws and (2) Gaskets for use with a 2" Heater Tube & Union. The Heater Flange Split Nut mounts to the heater tube using 2 screws to hold it in place and...

This part is a 2" which measures about 3" ID Heater Split Nut Kit which includes the split nut , (2) Screws and a gasket for use with a 2" Heater Union that would measure about 3" Edge to Edge on the threaded side. The Heater Flange Split Nut mounts to...

You are buying a 2" Heater Split Nut with 2" Slip X 2" Thread Heater Union Kit which includes the split nut , (2) Screws, 2" Slip X 2" Threaded Union and a gasket for use with a 2" Heater Union as well as a 2" Slip x 2" Street Slice Gate Valve. The...

This part is a Set of 2" Heater Split Nut with 2" Slip X 2" Thread Heater Union Kit which includes (2) split nuts , (4) Screws,(2) 2" Slip X 2" Threaded Unions and (2) gaskets for use with a 2" Heater Union. The Heater Flange Split Nut mounts to the...

You are buying a 2" Heater Split Nut with 2" Slip X 2" Thread Heater Union Kit which includes the split nut , (2) Screws, 2" Slip X 2" Threaded Union and a gasket for use with a 2" Heater Union. The Heater Flange Split Nut mounts to the heater tube...

This part is a Single of Jumper Wire that would go from a standard heater element Electrode Tab to the board Relay Spade Connector.. Loop for the heater side to female spade.. These can be used on 4.0kw to 5.5kw elements.. Circuit Board...

This part is a Set of Jumper Wires that would go from a standard heater element Electrode Tab to the board Relay Spade Connector.. Loop for the heater side to female spade.. These can be used on 4.0kw to 5.5kw elements.. Circuit Board...

This part is a Pressure Switch Cable that is 7" long and Universal for use on most SSPA, MSPA, T-MSPA, and some Hydroquip boards..

This kit is a Set of (2) Air Bleeder barbed plugs,(2) 3/8" x 3/8" Barb couplers, (2) 4" long pieces of 3/8" Tubing and Silicon sealer usually used on a Dynasty Hot Tub with Waterway Hot Tub Pump Face to bleed the air off the pump while filling the tub up...

This kit is a Set of (2) Air Bleeder barbed plugs and Silicon sealer usually used on a Dynasty Hot Tub with Waterway Hot Tub Pump Face to bleed the air off the pump while filling the tub up. I have seen these fittings in many brands just compare the...

This part is a 3" wide Air Valve Handle in Gray that fits some Dynasty Air Valves.  This Diverter handle Slides on the Air Control Valve Stem that measures about 1/4" and is used to operate the Air Valves and is for Dynasty Spa only. The...

This part is a 3" wide Air Valve Handle in Black that fits some Dynasty Air Valves. This handle Says Trevi instead of Dynasty but they are exactly the same.. Dynasty sent us Trevi instead of Dynasty because they  This Diverter handle...