Shop

4-port manifold with (4) 3/8" barbs and 1"s x 1"spg inlet/outlet   Barb/Port Size 3/8" Barb Port Type Barb (b) Number of Ports 4 Manifold Fitting Type Flow-Thru Manifold Plumbing Size "A" 1" Manifold Plumbing Type "A" Slip (s), Spigot...

This part is a Hydro Air 1" Top Draw Air Control Stem Assembly only.. It measures about 2 5/8" Across the top and the threaded hole this would screw in would be about 1 3/8" Wide.. the shaft from the bottom of the lid would be about 2 1/2".. See attached...

This part is a Gate Valve, 3 piece, 1-1/2" Slip x 1-1/2" Slip, Slice Valve..  3-Piece Gate Valve AssemblyWith plastic paddle. Reliable 3-piece body design allows unrestricted water flow and is easily disassembled for in-line servicing. Internal...

This part is a 1 1/2" Street X 1 1/2" Slip X (4) 3/4" Smooth Barbs manifold and a single barb plug in case you only need 3 barbs instead of 4. The Manifold receives a 1 1/2" pipe on the slip side which would measure about 1 7/8"...

This filter is 9 3/4" Tall x 4 5/8" Wide and is closed on the top and has a 1 1/2" mpt thin threaded nipple that measures about 1 13/16" across the threads. This filter fits some of the Jacuzzi Whirlpool hot tubs that are found under the names Jacuzzi...

Double pole contactor CoilContact 120 VAC 30amp res

"Magicmend" Pipe extenderSimply cut the bad fitting and remove it from the system. Glue the correct size Magicmend into place and replumb your new fitting

Start Capacitor1-7/16"dia x 2-3/4"hgt

This is a 1.5HP Impeller for an Aqua-Flo 48 Frame Side or Center Discharge FMHP, FMCP, FMVP, and TMCP Series Wet End 1.5HP Motor that has about 9.0 Amps on High Speed at 230V and 14.0 Amps at 115V. This Impeller fits between the Face and the Volute of...

You are Buying a Gray Notched 3 3/4" Spa Diverter Cap only. This is a NON  Buttress Cap if your cap has the word Buttress stamped in it look in our store for a Buttress cap. This Diverter Cap mounts on top of the Diverter Valve with...

This Part is a Single Jumper Strap for a Balboa, EL, VS, GL or GS, Heater to Board connection.. This part is made from Copper.. Measures 2" x 13/16" Circuit Board Application    Balboa Water GroupCircuit Board Model    EL,...