Shop

This part is an Air Control, CMP, Mini, 1-1/8" Hole Size, 1-11/16" Diameter, Crescent, White 1/2" Plumbing Connection Hole size 1-1/8"  

This part is a Balboa Original Version 4 Button Overlay for a MVP260 Topside for a Pump and a Light. This Overlay can be used to replace your original Overlay no matter what brand as long as the button configuration works out. On the overlay starting at...

This part is a Hot Tub Light 8' Wiring Harness with a 2 pin Amp Plug and a 12V Bulb with socket. The wire is 8' Long and has a standard socket at one end with a standard 12V bulb found in most hot tubs and an Amp Plug 2 pin at the other end...

This part is a Balboa 6 Button Overlay for a VL620S or VL600 Topside with Two Pumps and Light System. On the overlay starting at the left of the readout it reads Jets, Aux, Light and to the right is Warm, Mode, Cool. This Overlay has an Adhesive back you...

This parts is an Artesian, Resort Series, Filter, Cartridge, 50sqft, 2" male pipe thread, 6-3/4" Wide, 8" Tall.. Note The small filter found in the center between these filters can be found here.. Artesian, Resort Series, Filter, Cartridge, 6 sqft,...

This part is a Short 2 5/16" Long Coupling, 1-1/2"slip x 1-1/2"slip.. The slip side receives a 1 1/2" pipe or fitting that would measure about 1 7/8" Outside Diameter.. 

This part is (1) Multibody 1 3/8" Face Width Air Injector in Gray. This air injector requires a .60" hole size and comes with a small gasket , retaining nut and three different barb adapters to suit multiple plumbing scenarios. The adapters come in a...

This kit is a Set of (2) Standard Balboa Board Replacement Repair Relays along with (3) Spade to Spade Jumpers used to do a beef up Jumper Style repair on Some Balboa BP Boards and others... 

Corner pillow for the 2006-2008 Pilates H2O hot tubs made by Tatum Manufacturing in Tampa. This graphite gray pillow measures 20" x 7" and it doesn't have male pegs on the rear like many other pillows. It is made to slide into the grooves or indents in...

This item is a Set of 10 Rising Dragon Brand LED Single Light Lens... Light Wall Fitting, RD, Mini POL, 1/2" Hole Size, 11/16" Face Diameter, Clear, Lens, Point of Light With the Rising Dragon Pinnacle Light System, there is no complicated cabling or hub...

This item is a Set of 5 Rising Dragon Brand LED Single Light Lens... Light Wall Fitting, RD, Mini POL, 1/2" Hole Size, 11/16" Face Diameter, Clear, Lens, Point of Light With the Rising Dragon Pinnacle Light System, there is no complicated cabling or hub...

This part is a Hot Tub 2 3/8" Mini Light Lense Kit with the gasket, Nut, and Light Holder. The face size is 2 3/8" and the hole size is Approx. 1 5/8" to 1 3/4". This fits Artesian Spas and other Brand tubs that have a small light lens. The reason...