Pumps and Related Parts

You are buying a Set of (2) 1 1/2" Slip X 1 1/2" Pump Unions with Gasket or Oring that matches Unions. The Union recieves a 1 1/2" pipe or fitting on one side and then Screws to a 1 1/2" Wetend(Pump) Threaded Part on the other side. It will Glue to a 1...

This part is a Set of (2) 2" Slip X 2" Pump Union with Gasket or O-ring that matches Union.   The Union recieves a 2" pipe or fitting on one side and then Screws to a 2" Wetend(Pump) Threaded Part on...

This item is a 1/4" Air Bleeder Plug with Thin threads that can be found on the New style of a StaRite Dura-Jet DJ Series, Dyna-Glas/Dynamax, ABG, Dyna-Jet, TPE, Some StaRite Pool Multiports, Petair/ Pacfab Sand Filter systems and more. Note: This is not...

This part is a Jacuzzi® J Pump Style Pump Union that can be used on 1 1/2" or 2" Plumbing systems. This union can receive a 1 1/2" plumbing part inside the back of the union or a 2" Plumbing part glued to the outside of the...

This part is a Starter Capacitor that fits many 230V Pump Motors. When diagnosing pumps for a no start condition where it is powered up but just hums you can hand spin start the motor by taking a screw driver to the shaft in the back and spinning it or...

This item is a 1/4" Air Bleeder Plug with coarse threads that can be found on the old style of a StaRite Dura-Jet DJ Series Wetends only. The head of this plug will break off and leave the threads in the wet end face. You can take a flat screw driver and...

This part is a Starter Capacitor that fits many 115V Pump Motors. When diagnosing pumps for a no start condition where it is powered up but just hums you can hand spin start the motor by taking a screw driver to the shaft in the back and spinning it or...

Aqua-Flo Xp2 Flo-Master 48Frame Pump Face O-Ring Only fits around the Face of a Xp Pump Face exclusively for An Aqua-Flo Xp 48 frame pump which has 2" inlet and outlet which measures about 3" across the threads... If you have a Xp2 56frame 6.1" or 6'3"...

This Kit is an 4HP Impeller for an Executive 48 Frame Wet End up to 4HP Motor and a 56 Frame Wet End 4HP Motor. This Impeller fits between the Face and the Volute of an Executive Wet End. I would advise replacing the Seal when you replace...

This is a Flat Gasket for 2" Pump or Heater Union Extra Thick 1/4". It is a 2 7/8" Outside Diameter and 2 1/8" Inside Diameter.

This part is a latching Style Single Pole Dual Throw Switch 20 Amp Hole Through Mount with 1/8" Spout air connector and the Wire connects are 5/16" male quick connect tabs and required panel hole is 5/8". This switch is the standard or Universal...

This Seal Kit PS-3868 Seal is an Upgraded Better Viton Carbon Graphite Version of the PS-201 Seal used Primarily in Vico & Sta-Rite Wetends.It is 1 3/8" Across the back of the Spring Seal part that goes onto the Impeller and the Ceramic & Rubber...