Pump Wet Ends and Related Parts

  // Read This Note First!! NOTE: This Seal will NOT Fit Sundance® or Jacuzzi® Tubs with a Guangding LX Wet End for those parts click here Jacuzzi® & Sundance® LX Parts    This Seal Set...

// Read This Note First!! NOTE: This Seal will NOT Fit Sundance® or Jacuzzi® Tubs with a Guangdong LX Wet End for those parts click here Jacuzzi® & Sundance® LX Parts This Seal Set is used ONLY in...

You are buying a 1 1/2" Slip X 1 1/2" Pump Union with Gasket or Oring that matches Union. The Union recieves a 1 1/2" pipe or fitting on one side and then Screws to a 1 1/2" Wetend(Pump) Threaded Part on the other side. It will Glue to a 1 1/2" Pipe or...

This item is a face is for a Sta-Rite DuraJet DJ pump... This face plate does come with the new style plugs in it.. Material Type Plastic Volute With Seal No Volute to Seal Plate Mounting Type 4 Bolts 4 Nuts Suction Connection (Physical...

This Kit is an 1HP Impeller for an Executive 48 Frame Wet End up to 1HP Motor and a 56 Frame Wet End 1HP Motor. This Impeller fits between the Face and the Volute of an Executive Wet End. I would advise replacing the Seal when you replace...

This part is a 2HP Sta-Rite DJ Dura-Jet Pump Impeller.. This impeller will usually have the number 17400-0122 cast into the back and will measure about 3 3/4" wide with an eye width of 1 1 3/4" and a vane width of 1/2".. This can be found on motors with...

This part is a Pump Face for a Vico Ultima Side Discharge wet end that is 2" which measures about 3" edge to edge across the threads.. The Seal Kits for this pump can be found here: Vico Seals 201 The other parts for this pump can be found here: Ultima...

This part is a 2.5HP Sta-Rite DJ Dura-Jet Pump Impeller.. This impeller will usually have the number 17400-0123 cast into the back and will measure about 3 3/4" wide with an eye width of 1 3/4" and a vane width of 1/2".. This can be found on motors with...

This is a 4HP Impeller with a 2 1/8" Eye a 1/2" Vane Width and a 4 1/2" OD for an Aqua-Flo 48 or 56 Frame Wet End 4.0HP Motor which would have about 14.0A on high speed. This Impeller fits between the Face and the Volute of an Aqua-Flo XP2 or FMXP2 Wet...