Shop

This part is a 4 Button, E4, Topside, Balboa, Lite Duplex Digital, (1) Pump, (1) Blower, Temp, Light.. This Topside will work with a variety of boards, Valve, SUV, VS500, VS501 and more.. Manufacturer    Balboa Water GroupTopside...

The Waterway center discharge wet end has been discontinued and replaced with the E-Series Center Discharge wet end by the manufacturer. Please be sure which wet end you have as the parts are not interchangeable. The easiest way to identify which wet end...

You are buying a 3 HP 56 Frame Waterway Executive 2" X 2" Wet End / Pump complete with Screws, Volute, Impeller, Seal, Face and the Wear Ring. The difference between a 48 or 56 Frame wet end is the spacing of the Motor Thru bolts. The 48 Frame will be 3...

Potter&Brumfield S86 SeriesCoilAction120 VACDPD

Balboa Water GroupStainless steel replacement complete heater assembly, 5.5kW/1.375kW ,230v or 115v, this tube measures  2" Inside Diameter and the overall tube length is 15" not counting the split nuts. This heater includes M7 sensors, tailpieces,...

This Temperature Sensor Set has 1/4" probe widths on both probes.. This set usually found on tubs with no heater that uses a firestick or heat jacket to heat not a real heater... I have seen these on Dreammaker and other brands... The temp probe is...

This part is a Heater, FloThru, Universal Fit, 15" x 2", 230v, 4.0kW..  This heater will work in place of the following heaters: 1563-08 , 20-00245 , 20-00317 , 20-00318 , 20-00319 , 20-00324 , 20-00433 , 20-00434 , 20-00454 , 26-0034 , 26-0036-R1C...

This part is a Complete XP2e 6.3” 4.0HP Aqua-Flo 2" x 2" ( Which measures about 3" Across the Threads) Side discharge 56 frame wet end for XP2e pumps. This wet end is used with a 56 frame motor that would have about 14.0 Amps on High Speed on a...

Aftermarket Replacement for Cal Spa XL Exchanger This heater assembly is not an exchanger but an in-line flow thru replacement. This heater assembly is designed as a drop-in replacement. 2" x 15"s/s housing with 2" slip tailpieces

This item is a 48 Frame Vico Wet End with 2" x 2" inlet and outlet that would measure about 3" across the threads and it has a 2.0HP impeller which would fit a motor that has 10.0 amps at 230V and 16.0 amps at 115V.. Pump to Motor Foot Types  ...

You are buying a 5 HP 56 Frame Waterway Executive 2 1/2" X 2" Wet End / Pump complete with Screws, Volute, Impeller, Seal, Face and the Wear Ring. The difference between a 48 or 56 Frame wet end is the spacing of the Motor Thru bolts. The 48 Frame will...