Shop

This Kit is a Set of (2) Jacuzzi® J Pump Style Pump Union that can be used on 1 1/2" or 2" Plumbing systems. This union can receive a 1 1/2" plumbing part inside the back of the union or a 2" Plumbing part glued to the...

This part is a Diverter in a Kit which Includes the Diverter Valve, (3) 2" Couplers, (3) 6" Pieces of 2" Flex Pipe and (2) 2" Street Slip Ells. This Kit can be used to cut out an old Diverter and install this new Diverter in it's...

This part is a 3 3/4" Wide 2"slip x 2"slip x 2"slip Spa Diverter Complete Assembly Gray Valve.  The 2" Slip fittings receives a 2" pipe or fitting that would measures about 2 3/8" OD.. We also offer This Diverter in a Kit...

You are purchasing a Mazzei Brand Cap that fits a Model 584K or 684K Ozone Injector that is used inline to create suction to pull Ozone Gas from an Ozonator into the Hot Tub water. This Black or Red Injector Cap can be used in place of the Red or...

You are buying a Waterway Brand Flapper Tee Air Check Valve with a  1" Slip X 1" Slip Fittings on each end. This valve is used to allow air flow in one direct and to stop water flow in the other direction when plumbed properly in a Hot Tub. The...

This kit is a 2" Slip X Dead End X (4) 3/4" Barbs X (1) 3/4" Barb manifold repair kit for freeze damaged Cal Spa or Coleman Spas with 4oz of Christy's Red Hot Blue Glue. These manifolds are found on the left front side of the tub usually...

This kit is a 2" Slip X Dead End X (4) 3/4" Barbs X (1) 3/4" Barb manifold repair kit for freeze damaged Cal Spa or Coleman Spas. The manifolds are found on the left front side of the tub usually and has 4 lines and the drain attached to...

These are now obsolete now click this link for the solution.. You will not need all of these parts but we can't get it without them: Lo-Pro Floor Drain, 3/4" Slip Barb Ell, Dark-Silver-Glitter, 3-1/2" Face Width This part is a Cal Spa Hot Tub...

This part is a New Old Style 3 Terminal Power Block found on many Balboa Brand Spa Hot Tub Boards. This terminal Block can get burned on one leg if you can solder you can replace this part and not buy a board if this is the only issue with the...

This item is a CMP Brand LED Single Light Lens that features a 1" wide face and hole size of about 1/2"...      

This part is a Hot Tub 2 3/8" Mini Light Lense Kit with the gasket, Nut, and Light Holder. The face size is 2 3/8" and the hole size is Approx. 1 5/8" to 1 3/4". This fits Artesian Spas and other Brand tubs that have a small light lens. The reason they...

Thsi part is a Standard 5" Hot Tub Light Lense Kit with the gasket, Nut, Light Holder, 12V Bulb and Amp plug wire. The face size is 5" and the hole size is 3 3/4".This fits most tubs that have a large light lens but be sure to measure the hole there are...