Pumps and Related Parts

NOTE: This Part will Fit Sundance® or Jacuzzi® Tubs with a Guangdong LX Wet End if you replace the entire Wet End for internal parts of the wet end you already have click here Jacuzzi® & Sundance® LX...

// Read This Note First!! NOTE: This Seal will NOT Fit Sundance® or Jacuzzi® Tubs with a Guangdong LX Wet End for those parts click here Jacuzzi® & Sundance® LX Parts This Seal Set is used ONLY in...

This part is a Standard 2 1/2" Pump Union O-Ring. The O-Ring is 2 1/2" Center to Center across and fits some unions but there are exceptions so please see the pictures and compare. This part is used in hot tubs between a pump...

You are buying a 1" FTB X 1" Barb Pump Union with O-ring that matches the Union. The Union receives a 1" Inside Diameter Hose which measures about 11/4" on the outside and then Screws to a 1" Wet End (Pump) Threaded Part on the...

You are Purchasing a 12" piece of Clear Tubing that is 1" OD , 3/4" ID. These Tubing is used for connecting some Water Manifolds, Water Control Valves and Waterfalls in Hot Tubs. We Offer this Tubing with other parts in kits we are offering in our...

This Seal is a (BEST) Silicon Carbide Salt Resistant Upgraded Version of a PS-201 Seal used Primarily in Vico, Sta-Rite and Power Right Wetends. Silicon Carbide’s exceptional wear and chemical resistance, enhanced dry running capability and high...

This Seal is The (BEST) Upgraded Salt Resistant Silicon Carbide Version a PS-200 Seal used Primarily in Aqua-Flo Wetends but is found in Waterway " Viper" & "EX2" Wetends and some others as well.. Silicon Carbide’s exceptional wear and...

You are buying a 1 1/2" Slip X 1 1/2" Pump Union with Gasket or Oring that matches Union. The Union recieves a 1 1/2" pipe or fitting on one side and then Screws to a 1 1/2" Wetend(Pump) Threaded Part on the other side. It will Glue to a 1 1/2" Pipe or...

1 Speed Rotating Switch

This item is a face is for a Sta-Rite DuraJet DJ pump... This face plate does come with the new style plugs in it.. Material Type Plastic Volute With Seal No Volute to Seal Plate Mounting Type 4 Bolts 4 Nuts Suction Connection (Physical...

This Kit is an 1HP Impeller for an Executive 48 Frame Wet End up to 1HP Motor and a 56 Frame Wet End 1HP Motor. This Impeller fits between the Face and the Volute of an Executive Wet End. I would advise replacing the Seal when you replace...

This part is a 2HP Sta-Rite DJ Dura-Jet Pump Impeller.. This impeller will usually have the number 17400-0122 cast into the back and will measure about 3 3/4" wide with an eye width of 1 1 3/4" and a vane width of 1/2".. This can be found on motors with...