Pump Wet Ends and Related Parts

This video is about The Spa Guy showing You How To Clean a Rusty Shaft on an Aqua-Flo Pump.. This process is similar for all brand pumps.. Save Save Save Save Save

This video is about The Spa Guy showing How To Repair a Leaking bleeder plug on a Sta-Rite Dura-Jet Pump. it is a similar process on all brands.. Save Save Save

This video is about The Spa Guy showing How To Repair a Sta-Rite Dura-Jet Pump that either slow starts or Hums on Low Speed but will run on hgih and then on low after being on high but will not run on low from a dead start... it is a similar process on...

This video is about The Spa Guy showing How To Replace a Sta-Rite Dura-Jet Pump 201 seal and face o-ring... it is a similar process on all brands... Save

In this Video The Spa Guy goes through the repair and seal replacement on a Cal Spa Power Right pump and motor... Save

You are buying a Kit that features (1) PS-201 Seal and (1) Bearing that fit most motors that are mated to Vico, Sta-Rite, Dura-Jet and Power Right Pump Wet Ends and The Professor's Silly Juice to seal the seal. This Seal is used in Most Vico,...

This Kit Fits Watkins, Vendor #4081, Wavemaster Pumps found under the name Wavemaster 6000, 7000, 8000, 8200, 9000, 9200 numbers Features (1) Bearing & (1) Seal for 4081 Pumps on Hotspring Watkins Hot Tubs and (1) 1/2Oz Tube of The Professor's Silly...

You are Buying a Volute Face only for a Piranha A-series pump only. This Part is used mostly in Jacuzzi® and Sundance® hot tubs with this specific type of wet end and will not fit others. Note: This face is the replacement for the 6500-287 face...

You are buying a Kit that Features (1) PS-200 Seal for Aqua-Flo Pumps and (1) 1/2Oz Tube of The Professor's Silly Juice a Specially Formulated for Hot Tubs Silicon Sealer. This Seal is Used Primarily in Aqua-Flo Wetends and in Waterway " Viper" Wet Ends...

This O-Ring fits around the face of an Executive 48 or 56 Frame Wet End all Horsepowers and fitting sizes... This is (1) O-Ring ONLY!! Choose with care, I Do Not accept returns so be sure these are correct before...

This Part is a Set of (2) Standard 2" Heater or Pump Union Gasket with a lip that is 2 1/2" Center to Center. The gasket is 2 7/8" across on the outside the inside diameter is about 2 3/16" and the lip that fits into the union is...

This part is a set of (2) 2" Pump Union Split Nut Repair Kits which includes the split nut, (2) Screws and a T Gasket for use with a 2" Pump Union. The Pump Union Split Nut that measures about 3" on the Inside of the threaded side and mounts to...