Shop

You are buying a 2 HP 48 Frame Waterway Executive 2" X 2" Wet End / Pump complete with Screws, Volute, Impeller, Seal, Face and the Wear Ring. The difference between a 48 or 56 Frame wet end is the spacing of the Motor Thru bolts. The 48 Frame will be 3...

This part is a Complete XP2e 6.3” 2.5HP Aqua-Flo 2" x 2" ( Which measures about 3" Across the Threads) Side discharge 56 frame wet end for XP2e pumps. This wet end is used with a 56 frame motor that would have about 11.0 Amps on High Speed on a...

You are buying a Complete Replacement 4.0KW Heater Assembly that fits a Gecko SSPA or Spa Builders Pack. This Heater Assembly includes the Tub, Element, Pressure Switch, Split nuts and Gaskets. NOTE: If you have the old style SSPA board with the...

You are buying a 3 HP 48 Frame Waterway Executive 2" X 2" Wet End / Pump complete with Screws, Volute, Impeller, Seal, Face and the Wear Ring. The difference between a 48 or 56 Frame wet end is the spacing of the Motor Thru bolts. The 48 Frame will be 3...

You are buying a 5 HP 56 Frame Waterway Executive 2" X 2" Wet End / Pump complete with Screws, Volute, Impeller, Seal, Face, Wear Ring, Bleeder Barb and Silicon.  The Bleeder Barb Replaces one of the plugs and is used to reconnect your previous 3/8"...

Stainless steel aftermarket replacement heater assembly that fits systems that use dual sensor technology. 2" x 15" with two thd taps for the sensor assembly rated at 5.5kW/240v. Replacement sensors sold separately.

This pump is a Waterway Genesis Generation Energy Efficient Bath Pump 7.5 amps 115 Volts w/Air Switch The Plumbing connections are 1 1/2" on the Pressure and Suction sides which measure about 2 3/8" across the threads.. There are two barbed fittings on...

This item is a 48 Frame Vico Wet End with 2" x 2" inlet and outlet that would measure about 3" across the threads and it has a 4.0HP impeller which would fit a motor that has 12.0-14.0 amps at 230V and there are no 115V motors this fits.. Pump to Motor...

This part is a complete Heater, Flo Thru, Balboa M7, 800, 825, 15" x 2", 230v or 115v , 4.0kW, with Sensors..  This heater tube has a stud on the top and bottom make sure yours has them too.. This heater DOES include m7 sensors and split nuts, but...

This part is aflow-thru style is used on the 2006-forward Solana TX (triangle spa), RX (round) & SX (square) as well as the 2006-forward Hot Spot models except the Sprint and Dash. 15” length 4.0kWgrounding and mounting studsTemp Sensor or High...