Description
Please Note: Only One Threaded Drain/Bleeder Port
The original Aqua-Flo XP2/XP2e wet end faceplate had 3 threaded drain/bleeder holes. Newer wet ends now come with only one threaded port. The other holes are molded into the plastic but do not have threads cut into them. If your installation needs more than one connection, you will need to tap the extra hole(s).
The Aqua-Flo XP2e pump wet end uses 1/4"-18 NPSM straight pipe threads for the drain plug opening. To add the threads, you will need a 1/4"-18 NPSM straight pipe thread tap. Carefully cut the threads by hand, keeping the tap straight and backing it out periodically to remove plastic shavings. Do not overtighten the drain plug when installing it.
Important: Use an NPSM straight-thread tap, not an NPT tapered-thread tap. The original drain plug uses an O-ring to create the seal.
This is a Full XP2e Wet End Assembly from Aqua-Flo rated at 2.5HP with 2" x 2" plumbing connections (approximately 3" measured across the threaded fittings) featuring side discharge design for 56 frame configurations at 6.3" length. This assembly is engineered for 56 frame pump motors operating at approximately 11.0 Amps on High Speed setting with 230V power systems and is not compatible with 115v motor applications. Compatible with both single speed and dual speed motor configurations. The discharge outlet can be rotated 90 degrees for flexible installation positioning. This complete assembly arrives ready to install with: volute housing, seal assembly, impeller, wear ring, suction cover, suction cover o-ring, drain plug, drain plug o-ring and all necessary suction cover mounting screws.
For installations requiring a barb fitting on the wet end face for small hose attachment, consider these barb options with or without sealing compound. We recommend using silicone sealant for these fittings as traditional pipe tape does not provide reliable sealing:
Barb Adapter, 3/8"b x 1/4"mpt, Pump Wet End Face fits Aqua-Flo & CMP
Barb Adapter, 3/8"b x 1/4"mpt, With Silicon Kit Pump Wet End Face fits Aqua-Flo & CMP
Important: Always select your HP rating based on your motor's Amperage rating using the reference chart below. For reference: 48 frame motors measure approximately 5 1/2" across the motor body and feature 1/4" bolt heads on through-bolts with approximately 5 3/16" spacing between through-bolts in cross pattern configuration while 56 frame motors have different specifications