Shop

This part is a Repair Kit for a 5" Wide Master Spa Twilight Series Buttress Style Diverter Valve. This Kit comes with the Teardrop Handle, Buttress Cap and (2) Small O-Rings and (1) Large O-Ring. The Valve these parts fit is found on Master...

This part is a Handle Knob for a 5" Wide Master Spa Twilight Series Diverter Valve. This Kit comes with the 5" Six Spoke Handle. The Valve these parts fit is found on Master Spa Twilight Series but will fit many other brands too.  This...

This part is a Repair Kit for a 5" Wide Master Spa Twilight Series Buttress Style Diverter Valve. This Kit comes with the Teardrop Handle, Buttress Cap, Stem and (2) Small O-Rings and (1) Large O-Ring. The Valve these parts fit is found on...

This part is a Hydro Quip Versi-Heat remote heater replacement assembly. The metal tube measures 2" x 13" with a 5.5 kilowatt, 230v heater element inside. Some versions are 4.5kw but this one will work in place of that version without issue...

This part is a Cal Spa Silver Waterfall Control Cap 2 9/16" Wide Teardrop Style  only.  This Waterfall Cap Slides on the Diverter Valve Stem is used to operate the Wateffall Control Valve and is for Cal Spas.   This Part is...

This Part is a  Cal Spa 1" Spa Hot Tub Complete Air Valve "Swoosh Style". The Valve features a 1" Slip fitting on bottom and the hole size in the tube is 1 5/8".  For help please see our YouTube video below.

This part is a (4) Bolt head Screws and Washer Kit for 48 or 56 frame pumps used to mount pump motors down on wood based hot tubs.  Includes  (4) Screw head 1 1/8" Screws and (4) Washers.  For Most brands of hot tub pump motors, for...

This kit is used to convert the plumbing on some Dr. Wellness or Water's Edge Hot Tubs with a Chinese Energy Saver Control with an ET-H3000 or ET-H4000 remote heater that has the backwards unions to a more modern Control System set up.. NOTE: This is the...

This part is a Rubber Pump Motor Base Vibration Dampener with (4) Bolt head Screw and Washer Kit for 48 and 56 frame pumps. Includes 4 soft 'washers' to isolate mounting screws from touching the motor base along with (4) Screw head 1 1/8" Screws and...

This part is a Valve & Cap, Drain that offers a 1/2" slip or 3/4" barb connection. The hole size to mount this drain is about 1 1/4".  

HydroQuip Temperature Sensor, 72" with 1/4" diameter temp probe. Common to find these used on the Versi Heaters and 9700 series spa controls. Please Note: This 2 wire sensor will replace all previous 3 wire styles. For SSPA, USPA, MP, 6200, 9200, 6500,...

This fitting is a PVC Tee that features (3) 3/8" Barbs that receives a 3/8" ID pipe on all three sides. Note: Colors can vary.. The Smooth Style and Barbed Style both work well with vinyl tubing as in most cases 3/8" tubing in hot tubs is suction not...