Motor Parts

This part is a (4) Bolt head Screws and Washer Kit for 48 or 56 frame pumps used to mount pump motors down on wood based hot tubs.  Includes  (4) Screw head 1 1/8" Screws and (4) Washers.  For Most brands of hot tub pump motors, for...

This part is a Rubber Pump Motor Base Vibration Dampener with (4) Bolt head Screw and Washer Kit for 48 and 56 frame pumps. Includes 4 soft 'washers' to isolate mounting screws from touching the motor base along with (4) Screw head 1 1/8" Screws and...

This part is a Rubber Pump Motor Base Vibration Dampener for 48 and 56 frame pumps. Includes 4 soft 'washers' to isolate mounting screws from touching the motor base. This motor base mounting pad fits under any 48 frame pumps, and under most 56...

This part is a Stationary Switch that fits in the back of some A. O. Smith Motors also Century and Regal Beloit.. This switch is about 2" wide, 2 1/2" Long and 1 3/8" Tall.. Motor Brand    A.O.Smith/Regal BeloitMotor Parts Type  ...

Start Capacitor1-7/16"dia x 2-3/4"hgt

Start Capacitor1-7/16"dia x 2-3/4"hgt

Start Capacitor1-7/16"dia x 2-3/4"hgt

Start Capacitor1-7/16"dia x 2-3/4"hgt

You are buying (1) Bearing that fit some motors that are used in hot tubs, usually small 48 frame motors and some circulation pumps, this bearing is 15.9MM ID x 40MM OD. Some of the motors this fits are A.O.Smith/Regal Beloit, Century/Regal Beloit,...

Start Capacitor1-7/16"dia x 2-3/4"hgt

This part is a Starter Capacitor that fits many 230V Pump Motors. When diagnosing pumps for a no start condition where it is powered up but just hums you can hand spin start the motor by taking a screw driver to the shaft in the back and spinning it or...

This part is a Starter Capacitor that fits many 115V Pump Motors. Start Capacitor, 161-193 MFD, 115v, 1-7/16" x 2-3/4" When diagnosing pumps for a no start condition where it is powered up but just hums you can hand spin start the motor by taking a screw...