Shop

This part is a Cal Spa Original M7 Style 5.5KW Heater Complete Assembly includes Tube, Element Split nuts and Gaskets. This unit features a 5.5Kw Element, Tube with (2) Split Nuts and gaskets. This heater replaces the heater inside of the bottom of a Cal...

Vico, Big Foot Pump Impeller, Found on many different brands but on some Sundance Brand tubs too.. Closed face impeller made for the Big Foot spa pumps by Vico. Rated at 2.5hp,which would be 10-11.0 Amps.. Click here for the Seal for this impeller Vico...

Vico, Big Foot Pump Impeller, Found on many different brands but on some Sundance Brand tubs too.. Closed face impeller made for the Big Foot spa pumps by Vico. Rated at 4.0hp,which would be 13-14.0 Amps.. Click here for the Seal for this impeller Vico...

This part is a Complete Heater Tube and Element that fits Vita Spas build by DM Industries.. Stainless steel 5.5kW/230v, 2" x 17-3/4" flow thru replacement heater assembly with a pressure switch tap at 0 degrees from the heater terminals. Includes a...

This part is a Replacement Bottom Drain Fitting Kit found on Artesian and Resort Hot Tubs. Remove the cracked inside the floor top Fitting and replace with this one by adding the screwing the new face into place. Although this is a complete kit including...

You are buying on a Renu Kit for 1" Street X (4) 3/4" Barbs manifold to be used to replace old manifolds with 3/4 or 1" glue in white pipes. The Manifold recieves a 1" pipe on the slip side which would measure about 1 1/4"...

You are buying on a Renu Kit for 1" Street X (4) 3/4" Barbs manifold and Glue to be used to replace old manifolds with 3/4 or 1" glue in white pipes. The Manifold recieves a 1" pipe on the slip side which would measure about...

You are buying on a Renu Kit for 1" Street X (4) 3/4" Barbs manifold and Glue to be used to replace old manifolds with 1/2" glue in white pipes. The Manifold recieves a 1" pipe on the slip side which would measure about 1...

You are buying on a Renu Kit for 1" Street X (4) 3/4" Barbs manifold to be used to replace old manifolds with 1/2" glue in white pipes. The Manifold recieves a 1" pipe on the slip side which would measure about 1 1/4" inside...

You are buying on a 1" Street X (4) 3/4" Barbs manifold. The Manifold recieves a 1" pipe on the slip side which would measure about 1 1/4" inside Diameter and then glues inside of a slip on the street side on the other...

This Part is a White 2 5/8" Face Width Replacement Knob for Waterway, Hydro-Air or CMP Brand Waterfall Control Valves.. The Bottom Accepts a 5/8" wide Square Stem and we offer these in Black, Gray and White.. See the link below..  Knob,...

This item is a White Notched Replacement Diverter Cap for a 1" Waterfall or Neck Jet Control.. The inside thread measurement is about 1 5/8" and the center hole is about 3/4".. It uses (2) Small o-rings and one O-Ring Gasket that measures...