Shop

This part is an 11 button Gecko Aeware topside complete with a 10ft cord that is used in systems base on the IN.K600 part number.. Dimensions 4-1/4" x 8-11/16" With its stunning design, Aeware by Gecko's new in.k600 advanced control panel features a low...

This filter is Designed for the Coast Hot Tubs 21 5/16 tall X 5 5/16" and has 2 1/8 holes top and bottom...  And fits   Diameter 5-5/16" Length 21-5/16" Top Style Open Top Physical Dimension 2-1/8" Bottom Style Open Bottom...

We are offering a Pre--2002 Master Spa Cartridge Filter 8" x 9 1/4" Wide 2"mpt 70sqft Master Spa Most 1998,1999, 2000. This filter is 8" long x 9 1/4 " Wide and has   2"MPT which measures about 2 1/4" Across . The overall length of this housing...

This part is a Set of (2)Reinforced Smooth Gray 4" Spa Diverter Handle Knobs only.  These Diverter Knobs has a smooth top for a more classic look and easier handling as well as a Galvanized Steel reinforced receiver and mounts on top of the...

This Face Plate O-Ring Is 5 1/8" Inside Diameter and is 1/8" Thick. It is found on Aqua-Flo 1 1/2" x 1 1/2" (Which Measures 2 3/8" Outside of the threads on the Sunction and Pressure Side of the Wet End) These Wet Ends used the names Flo-Master,...

This Mixing Chamber Repair Kit fits the American Products Pentair Luxury Micro Jet body's that are used with the (2) Tab Style Jets that are pictured in the photo section with the measurements and are used to be able to turn off the water flow from the...

Drain Plug with O-Ring for Waterway Wet Ends Fits Executive, Viper, Hi- Flo, Iron Might, Spa Flo, Supreme, Mustang, Workman and More  We also offer the 3/8" Barb that replaces these plug in the case of using a Pump Bleeder System... This are found...

This Wear Ring only fits Waterway Executive 4 or 5HP Impellers for a 48 or 56 Frame Pump Wet Ends and measures 13/16" thick from front to back or some Intertek impellers... If you have a Waterway Executive 1,2 or 3 Horsepower Wet End it will require...

This Part is a Thermodisc Style Surface Mount HI LIMIT: Single Pole Single Throw THERMAL FUSE Auto Reset (With NO CAPILLARY)This Hi Limit Surface mount surface mounts to the heater in a spot where it can read what the actual water temperature is flowing...

This Tool is used to install Luxury Micro Jet Body Front Flanges...  

You are buying on a 4.0KW Titanium Heater Element.  This Heater Element features the bend in the back of the element needed to fit the Balboa M-7 heater tubes. This also fits Gecko, ACC, Spa Guts, Spa Builders Len Gordon, Brett Aqualine,...

This part is a Pump Motor Starter Capacitor.. it is a 88-108 MFD or Microfarad.. 250V   This capacitor measures 1-13/16"diameter x 3-3/8" Long  Special Technical Note: The Capacitor is sometimes the cause of your motor not operating but often...