Digital Control Systems and Parts

This video is The Spa Guy teaching you how to Diagnose a New Wire Up Situation where you just wired your hot tub up and it is tripping the breaker and it is either a new tub or it is used and ran fine at the last location...... Save

This video is about The Spa Guy shows you how he diagnosed a bad Pressure Switch for a FLO Code after the tub was powered up...     #sparepair #hottubrepair Save Save Save Save

This part is a New Old Style 3 Terminal Power Block found on many Balboa Brand Spa Hot Tub Boards. This terminal Block can get burned on one leg if you can solder you can replace this part and not buy a board if this is the only issue with the...

This part is a 5 Position 50 Amp Terminal Block found in Balboa Lite Leader Packs and some others..  Terminal Type    Terminal BlockTerminal Style    Terminal Block/StripNumber of Connections    5Terminal...

You are purchasing a New Balboa 52295 Non M7 Spa Hot Tub Board. Watch the video for more information including some diagnostic tips.. This board does use a pressure switch.   Board is used with an E7 Topside and can run up to two pumps and...

T90 Style Circuit Board RelayCircuit board mounted, available in various coil voltages. Use to complete simple circuit board repairActionCoilAmpsSPST12 VDC30amp

Vita Spa Circuit BoardThe following topside(s) are compatible with the above circuit board: 58-103-100402-18-11 There is now a revision to this board. A resettable fuse has been added to protect the board from being damaged when hooked up to a defective...

This Balboa Board is a VS-500 meaning it is a one jet pump board that will run a 12V light and a Circulation Pump also if equipped... This board can be found under all of these numbers and more......

This part is a Ground Bar found on many Balboa Brand Spa Hot Tub packs as well as some Gecko SSpa and Mspa packs.

This part is a Standard Balboa Heater M7 Sensor with a 31" wire found in Jacuzzi Premium J series 2016 to current.    Application Balboa Water Group Sensor Diameter 1/4" Wire Length 31" ...

This part is a Daughter Board 1 (DB-1) Kit for Waterway NEO 2100 Spa Control System. Used to add an extra 2-Speed pump to the system.Kit Includes: (3) 1/4" Hex #6-32 x 1.5" Standoffs, (3) Screws and (1) Zip Tie. NOTE: WE DO NOT ACCEPT RETURNS ON...