Hot Tub Parts by Tub Brand

This part is aSpa Diverter Valve Internal Stem only. This Diverter fits many different brands but it looks similar to some brands that it will not fit so be careful in your choice, check the measurements against your old stem valve and watch the...

 This filter is 13 1/2" X 4 15/16" and has a female SAE Large Thick Thread that is 2" which would really nmeassure about 2 1/4-2 3/8" ID. This filter is found in Four Winds Tubs, Barefoot and others. If you have the shorter verison of this filter...

This part is an Air Switch, Tecmark, TBS 339, SPNO, 25 Amp, Threaded, Latching.. Wire connects are 5/16" male quick connect Spade Type tabs and required panel hole is 5/8"..25 AmpSingle Pole Normally OpenLatching Style Switch Note: The Nut Style can vary...

This part is a 5.5KW Sundance Sentry 850 / 750 Smart Heater Complete Assembly includes the Body, Element, Case and Manual Bimetallic Hi Limit with wires. This unit features a BiMetallic Backup high limit and the wires that tie to the board and is exactly...

Gemini Plus II Pump Complete with wet end and Air Switch... 1 1/2" X 1 1/2" which measures about 2 3/8" across the threads.. Specifications are .75 HP 115Volt 8.5Amps... For high flow bath jet systems Length = 12-11/16" Width = 5-11/16" Discharge...

This Filter cartridge is 5 5/16" Wide X 10 1/8" Tall.. It has a 2 1/8" hole on the top and bottom... it is 45 Sq Ft and is found in a lot of different brands... Dynasty Spas, Garden Leisure, Leisure Bay, Recreation Warehouse, Rainbow,Pentair,...

This item is a Black Replacement Diverter Cap for a 1" Waterfall or Neck Jet Control.. The inside thread measurement is about 1 5/8" and the center hole is about 3/4".. It uses (2) Small o-rings and one O-Ring Gasket that measures about 1 1/2"...

This circulation pump is found from the factory in many hot tubs and will be an easy installation for people who are handy.   This pump is a 48 frame 115V Side Discharge wet end with a 1 1/2" suction side and 1 1/2" pressure side which measures...

This filter is found only in Sundance Hot Tubs that is 19" long x 8 1/2" Wide and it has a hole in one end that is 2 1/2" and a nipple on the other end that is 2". This filter can be used in place of the old style filter combination one filter number...

Standard Pump Union Adapter Assembly With this adapter you can convert a 2" Threaded Pump Union whcih measures about 3" I.D. to a 1 1/2" threaded fitting which = 1 7/8" O.D. standard wet end. An O-Ring does come with this fitting but if you just needed...

2" Top Access Diverter ValvesAvailable in scalloped or notched style. 3-1/4" hole required

This part is an Jacuzzi J Pump Impeller Wear Ring.. It measures about 1 15/16" ID and 2 7/16" to the outermost OD..  Fits the following pumps: Cygnet Series - All Horsepowers J, JCM, K and KM Series - All Horsepowers L, LC, LCUN2, LT, LX,...