Description
This genuine replacement impeller is engineered for Aqua-Flo 48 Frame wet end assemblies in FMHP, FMCP, FMVP, and TMCP Series configurations. Designed specifically for 1HP motors operating at approximately 8.0 Amps on high speed (230V systems), this component sits securely between the face and volute housing. Compatible with both side discharge and center discharge models, this impeller works with motors showing 11-12.0 Amps at 115V or 8.0 Amps at 230V on high speed settings. We strongly recommend installing a new seal during impeller replacement - this unit requires a PS-200 / HTP35-423-1020 seal assembly available separately. Important sizing information: 48 Frame wet ends feature motor thru-bolt spacing of 3 5/8 inches between bolts or 5 3/16 inches in X pattern configuration with 1/4 inch bolt heads, compared to 56 Frame models at 4 1/8 inches between or 5 3/4 inches in X pattern with 5/16 inch bolt heads. Critical Warning: Never install an oversized impeller attempting to increase pump performance - this causes motor overheating, high speed operation failure, and potential damage due to incompatible wear ring sizing. Always verify your motor's amperage rating using the specifications above before ordering. All sales are final on this precision component, so please confirm compatibility carefully.
