Description
This is a 1HP Seal, (1) Bearing & Impeller Kit for a Watkins 37334 Vendor Code# 4081 Pump with a 2 1/8" Eye with 1/4" Vane Width and 3 7/8" OD for an Wavemaster 48 1.0HP Motor would be about 7-8.0 Amps on high speed at 230V or 11-12.0 Amps at 115V. Note: A 115v motor that uses a 1 HP Impeller would show about 11-12.0 Amps on high speed a 230V motor would show about 8.0 Amps on High. See chart below for other Horsepowers. Do Not choose a Larger Impeller thinking that it will make your Hot Tub Stronger it will only damage the Motor and make it run hot on high speed. To determine the HP refer to the chart below.. The difference between a 48 or 56 Frame wet end is the spacing of the Motor Thru bolts. The 48 Frame will be 3 5/8" between or 5 3/16" in a X Pattern and have a 1/4" Bolt Head and the 56 Frame will be 4 1/8" Between or 5 3/4" in a X Pattern and have a 5/16" Bolt Head.
Vendor Code 4081
If you only want the seals or seal and Bearing Kits here are the ones for this pump:
Hotspring, Watkins, Vendor #4081, Shaft Seal Kit, Silicon & Tool Buna Fits XP2 Model Wet Ends Only
| Impeller Type | Closed Face |
| Impeller Diameter OD | 3-7/8" |
| Vane Width ID | 1/4" |
| Eye Diameter OD | 2-1/8" |
| Eye Length | 3/4" |
| Impeller Width OD | 1/2" |
| Seal Seat Depth | 1/8" |
| Shaft Length | 1-1/2" |
| Shaft Diameter OD | 5/8" |
| Seal Seat Diameter OD | 1-1/4" |
| Manufacturer | AquaFlo/Gecko |
| Pump Application | XP2 |
