Caps & Plugs Plumbing Fittings

This is a plug used to plug off a 3/8" port on Air manifolds or Air Sides of Jet Bodies that are above the water line of the tub. We offer many different plugs based on the brand of manifold.

This part is a Hot Tub Replacement Bottom Drain Inside Wall Fitting with a 3/4" slip fitting which measures about 1" I.D.. This part is on the foam side of the tub and the Fitting screws into this fitting.. You have to stand the hot tub up and dig into...

These are now obsolete now click this link for the solution.. You will not need all of these parts but we can't get it without them: Lo-Pro Floor Drain, 3/4" Slip Barb Ell, Dark-Silver-Glitter, 3-1/2" Face Width This part is a Cal Spa Hot Tub...

This part is a Hot Tub Replacement Bottom Drain Inside Wall Fitting with a 3/4" slip fitting on each end which measures about 1" I.D.. This part is on the foam side of the tub and the Fitting screws into this fitting.. You have to stand the hot tub up...

This is a 1" Slip x Spigot Plug which measures 1 5/16" OD on one end and 1 5/16" ID on the other side it can be used to plug off a 1" Slip port which measures 1 5/16" ID on a manifold or other fittings or Cap a 1" Slip fitting that would measure about 1...

This is a Set of (3) barb plugs used to plug off a 3/8" port on Air manifolds or Air Sides of Jet Bodies that are above the water line of the tub. We offer many different plugs based on the brand of manifold.

This item is a 1/8" MPT Plastic Plug which can be used to block an 1/8" MPT (male Pipe Thread) hole normally found on a Heater Tube on Hot Tubs. This hole size is the same size as a Pressure Switch hole and would measure about 3/8" wide across the hole...

You are Buying a Lo-Profile Drain Assembly, 3/4" Barb, Black, 1-15/16" Face Width Replacement Bottom Drain Fitting Kit found on many brands of Hot Tubs. Remove the cracked inside the floor top Fitting and replace with this one by simply adding silicon...

You are Buying a Silicone Kit & Lo-Profile Drain Assembly, 3/4" Barb, Black, 1-15/16" Face Width Replacement Bottom Drain Fitting Kit found on many brands of Hot Tubs. Remove the cracked inside the floor top Fitting and replace with this one by...

This part is a Replacement Bottom Drain Fitting Kit found on Artesian and Resort Hot Tubs. Remove the cracked inside the floor top Fitting and replace with this one by adding the screwing the new face into place. Although this is a complete kit including...