Description
Tecmark 1 Amp Pressure Switch for Hot Tub and Spa Applications
This universal pressure switch is designed for digital hot tub control systems with low amperage requirements. The switch features 1/8" MPT standard threads and dual spade connectors for simple two-wire hookup.
Key Specifications:
- Amperage Rating: 1 Amp
- Thread Size: 1/8" MPT
- Connection Type: 2 Spade Connectors
- Compatibility: Universal fit for Balboa, Gecko, ACC, Hydroquip, Len Gordon, Maddux, and most standard hot tub heater tubes
How It Works:
This pressure-activated switch closes when your pump activates and creates pressure, then opens when the pump cycles off. Failure to close or open properly typically triggers a flow error code on digital control systems. Before replacing, verify that your pump is operational and your filter is clean, as these issues can also cause flow codes.
Application Notes:
This 1 Amp switch is intended for modern digital control systems where minimal current passes through the switch itself. This component is NOT suitable for air button systems that route heater power directly through the switch, which require 20-25 Amp switches (typically found only in certain 115V air button configurations).
IMPORTANT WARNING:
Do not attempt to adjust this pressure switch under any circumstances, as doing so voids the warranty. If adjustment seems necessary, there is likely an underlying issue elsewhere in your system. Contact customer support for troubleshooting assistance before making any modifications.
