Shop

This item is a Complete Suction Fitting that requires a 3 3/8" hole... The cover is 5 3/16" Wide... The plumbing size is 2" which would measure about 2 3/8" Outside Diameter o the pipe that glues in.. If your plumbing is 1 1/2" you would need a 2" to 1...

CMP Spa jet Internal Directional jet with 5 scallop trim and smooth finish in black. This older jet series has a 2.5" face diameter and only works in its jet body. These jets are in limited supply! Note: These jets have 23208 Cast into the back of the...

Male quick disconnect for Balboa plug and click heaters. This 16" adapter will connect to your heater element terminals and will either plug directly into the circuit board on BP systems or into the 25696 female adapter on the new Balboa VS, GS and EL...

This part is a Sundance Jacuzzi, Filter Suction Adapter Fitting, 2" MPT, Filter Pipe w/ Jam Nut.. This part threads into the wall of the hot tub and you slip the open hole end of the filter over this part then lock the crown side of the filter into...

NOTE: IF YOU ARE OUTSIDE OF THE 48 UNITED STATES DO NOT ORDER THIS GLUE KIT AS WE CANNOT SHIP IT.  This part is a Diverter in a Kit which Includes 4oz of Hot Blue Glue and 4oz of Purple Primer and the Graphite Gray Diverter Valve, (3) 2"...

This part is a Diverter in a Kit which Includes a Graphite Gray Diverter Valve, (3) 2" Couplers, (3) 6" Pieces of 2" Flex Pipe and (2) 2" Street Slip Ells. This Kit can be used to cut out an old Diverter and install this new Diverter in it's place. You...

This part is a 3 3/4" Wide 2"slip x 2"slip x 2"slip Spa Diverter Complete Assembly Graphite Gray Valve.  The 2" Slip fittings receives a 2" pipe or fitting that would measures about 2 3/8" OD.. We also offer This Diverter in a Kit...

This Impeller and Seal Kit is used ONLY in Intertek WTC50 Pumps Only. The impeller may have the number B432-01, B432-02, B432-03, B432-04, B432-05 on the back. The impeller measures about 3 5/8" across but the size can vary but this impeller is the...

This Seal Set is used ONLY in Intertek WTC50 Pumps Only. It is 1 39/64" Across the back of the Spring Seal part that goes into the volute or wetend back and the Ceramic & Rubber part that goes into the impeller is 1 11/32". The Hole in the...

This Pump is a Replacement for a 0974101-03 or 0974001-03 1.5 HP 230V 8.0/2.6 Amp (2) Speed 48 Frame Complete Pump  It is about 7 1/4"" across the face of the pump, it measures about 7 3/8" from the bottom to the top of the pressure side of the...

The ProAqua™ Spa Disc Oil & Scum Remover is an innovative floating device designed to attract and remove oils, lotions, and surface contaminants from your spa water. Each ProAqua™ Spa Disc Oil & Scum Remover is manufactured to...

This part is a Complete Wet End for Vendor Code 3536 with pump numbers 39578-03, 0982601-03 or 37066-03. This is a LX Brand Replacement Wet End Pump with a  2" X 2" 2.5HP 230V Vendor Code 3536 only.   It is about 7 1/4"" across the face of the...