Shop

This item is a 1/8" MPT Brass Plug which can be used to block an 1/8" MPT (male Pipe Thread) hole normally found on a Heater Tube on Hot Tubs. This hole size is the same size as a Pressure Switch hole and would measure about 3/8" wide across the hole or...

This part is an Aqua-Flo XP2 Impeller for a 2.0HP Motor which would have an Amperage Rating of about 10.0Amps on High Speed at 230V and 16.0 Amps on High Speed at 115V... It will also be a 56Frame motor which would have a 5/16" head on the through bolts...

The "Smart" Check is equipped with a 1/2Ó lb spring-loaded gate mechanism, allowing the valve to be installed in virtually any orientation.

THis part is no longer available.. 

Balboa Water GroupStainless steel replacement heater assembly, 4.0kW, 230v or 115v, the inside Diamater of the tube is 2" and the overall length of the tube is 15" not including the split nuts on each end. This comeplete heater includes M7 sensors,...

Note: The Jag-3 air switch is obsolete and you will receive the new retro-fit replacement option. Its possible you may need to adjust the hole size in your control box a s the Jag-3 used a 3/8" hole and the new units a 9/16" or you can mount the switch...

This is a .75HP or 3/4HP Impeller for an Aqua-Flo 48 Frame Side or Center Discharge FMHP, FMCP, FMVP, and TMCP Series Wet End .75HP Motor that has about 7.0 Amps on High Speed at 230V and 7-8.0 Amps at 115V. This Impeller fits between the Face and the...

Waterway Air Control Handle  Square Hole size about 9/32" to fit on top of the air control..

This part is a Stationary Switch that fits in the back of some A. O. Smith Motors also Century and Regal Beloit.. This switch is about 2" wide, 2 1/2" Long and 1 3/8" Tall.. Motor Brand    A.O.Smith/Regal BeloitMotor Parts Type  ...