Shop

This is a White Air Injector Jet and Body. it is a  Top Flow Type and receives a 3/8" Inside Diameter Tube, it features a 3/8" Outside Diameter 90° Ell Barb and is a Salt & Pepper Style... The hole size in the hot tub shell is 1 3/16" and...

This valve cap has been discontinued and we are working on a modern replacement. Until then you can replace the complete valve with ease using one of our waterfall kits. See below Hot Tub Spa Part Gray Waterfall Valve with (2) Straight Barbs Video How...

Fuse Holder

Vico, Ultimax Pump ImpellerClosed face impeller made for the Ultimax spa pump by Vico. Rated at 3.0hp,which would be 8-10.0 Amps.. it is used in an Ultimax pump wet end, and must be installed on a 2.0hp (or greater) thru bolt motor.  Click here for...

Gemini Plus II Pump Complete with Wet End and Air Switch... 1 1/2" X 1 1/2" which measures about 2 3/8" across the threads.. Specifications are 1.5 HP 115Volt 12.5Amps... For high flow bath jet systems Length = 12-11/16" Width = 5-11/16" Discharge...

Enclosed Circuit Board RelayCoil contacts are on bottom of relay at PC board. Trace saver tabs are available at top of relay ActionCoilAmps SPST-NO 12 VDC 30amp Coil Voltage Type    DCRelay/Contactor Style  ...

You are purchasing a Balboa Board Fuse Repair Jumper for board soldered on fuses found on many Balboa Brand Spa Hot Tub Boards. This jumper features a fuse holder with a .5A replaceable Fuse that can be added to any soldered on board fuse that has been...

This part is a Universal Replacement for all Mini Storm Jets Styles and Colors that have been discontinued.. Complete Jet Internal, Waterway, Mini Storm, 3" face diameter, Directional, 5 Scallop, Sterling Silver.. This jet is a Snap in Style not a...

Waterway PlasticButton style single hole air injector with 5/16" barb fitting. 3/8" hole required for installation

Start Capacitor1-7/16"dia x 2-3/4"hgt

This parts is an Executive 2 1/2" Mpt Threaded Face plate assembly (Which will measure about 3 11/16" Across the Threads) less the O-rings, Screws, Bleeder Plugs and other hardware needed to attach it to the volute..There is another version of the face...