Shop

Union fitting/part for 1/16 Hp Circulating Pumps

This part is a Filter Cartridge 75sqft 13" x 8" with 2 1/16" Top hole and 2" Male Slip Bottom Coleman Spa. This filter is found only in Coleman Hot Tubs that is 13" long x 8" Wide and it has a hole in one end that is 2 1/16" and a nipple on the other...

This part is an Aqua-Flo XP2 Impeller for a 4.0HP Motor which would have an Amperage Rating of about 14.0Amps on High Speed at 230V and Not applicable for 115V Pumps... It will also be a 56Frame motor which would have a 5/16" head on the through bolts.....

  This is a 1HP Impeller with a 2 1/8" Eye with 1/4" Vane Width and 3 7/8" OD for an Aqua-Flo 48 or 56 Frame Wet End 1.0HP Motor would be about 8.0 Amps on high speed at 230V or 12.0 Amps at 115V. This Impeller fits between the Face and the Volute...

Hi LimitsSingle pole rated at 25 amps with temperature rating set at 121°F. Best results are obtained when the bulb is installed in a dry well or groove tube at or immediately before the heater36" capillary length, 1/4" bulb thicknessThis is a safety...

This is a 230V Waterway Tiny Might Circulation Pump that is 1" x 1" which measures about 1 7/8" to the outside of the threads. It is high in efficiency and low on power use. Tiny Might packs a not-so-tiny punch. The Tiny Might offers you a great low flow...

This part is the Cord Side Male AMP Connector that houses (2) Male Pins.. The Pins are not included.. This connector is used often on light cables.. Terminal Type AMP Terminal Style AMP Plug Housing Male Number of Connections 2 Terminal Amperage...

This part is a Old Style Glue in Manifold, 3/4" Slip, 8 Port, Flow Thru, 1-1/2" Slip x 1-1/2" Spigot/Street.. Barb/Port Size    3/4"Number of Ports    8Manifold Fitting Type    Flow-ThruManifold Plumbing Size...

This filter cartridge is 9" Tall x 6' Wide and features a 1 1/2" MPT screw in nipple which measures about 1 13/16" to the outside of the threads. This filter is found in LA and Advanced spas and more.     Diameter 6" Length 9" Top Style...

"Magicmend" Pipe extenderSimply cut the bad fitting and remove it from the system. Glue the correct size Magicmend into place and replumb your new fitting