Shop

This item is a White Notched Replacement Diverter Cap for a 1" Waterfall or Neck Jet Control.. The inside thread measurement is about 1 5/8" and the center hole is about 3/4".. It uses (2) Small o-rings and one O-Ring Gasket that measures...

This 1" Waterfall Control Plunger Replacement Kit is found in some 1" Waterfall or Neck Jet Control valves. This kit features the plunger and stem, The Gasket for the bottom of the plunger and clip that holds the stem inside the cap and an o-ring kit for...

This part is a Jet body that is used with HydroAir Fixed 1 1/2" Wide Face Bullet or Ozone Style Jets...Rated at 3-4 gpm and requires a 3/4" hole in the shell.. The pipe connection is 1/2" which measures about 3/4" OD... For Jet Faces used with this body...

The MODPACK 101 is a universal replacement spa control system. Heater assembly is 15″ long, it is mounted to the back of the enclosure. To simplify the replacement process, heater tube height is adjustable so it aligns to...

This valve cap has been discontinued and we are working on a modern replacement. Until then you can replace the complete valve with ease using one of our waterfall kits. See below Hot Tub Spa Part Gray Waterfall Valve with (2) Straight Barbs Video How...

This valve cap has been discontinued and we are working on a modern replacement. Until then you can replace the complete valve with ease using one of our waterfall kits. See below Hot Tub Spa Part Gray Waterfall Valve with (2) Straight Barbs Video How...

This item is a Replacement Diverter Cap and O-ring Kit for a 1" Waterfall or Neck Jet Control.. The inside thread measurement is about 1 5/8" and the center hole is about 3/4".. It uses (2) Small o-rings and one O-Ring Gasket that measures about 1 1/2"...

This part is a Starter Capacitor that fits many 115V and 230V Pump Motors. When diagnosing pumps for a no start condition where it is powered up but just hums you can hand spin start the motor by taking a screw driver to the shaft in the back and...

This Part is an 48 Frame 2.0HP TMCP Aqua-Flo Wet End for a Garden Tub Bath Pump that has a voltage of 115V and an Amperage of about 16 Amps..  Note: The outside measurement of the threads on this wet end are about 2 3/8" meaning the inside...

This Part is an 48 Frame 1.5HP TMCP Aqua-Flo Wet End for a Garden Tub Bath Pump that has a voltage of 115V and an Amperage of about 14 Amps..  Note: The outside measurement of the threads on this wet end are about 2 3/8" meaning the inside...

This Part is an 48 Frame 1.0HP TMCP Aqua-Flo Wet End for a Garden Tub Bath Pump that has a voltage of 115V and an Amperage of about 12 Amps..  Note: The outside measurement of the threads on this wet end are about 2 3/8" meaning the inside...