Description
Complete service kit designed for Waterway Viper 3.0HP pumps featuring a closed face impeller, shaft seal assembly, dual bearings, installation tool, and silicone. Compatible with Viper pumps having 2 1/2" inlet and outlet connections that measure approximately 3 9/16" across the threads. This 3HP impeller configuration is typically paired with 10amp motors.
Important: The Viper series requires a unique seal design that differs from standard Waterway pump models. This specialized seal system ensures proper operation with the 2 1/2" x 2 1/2" wet end configuration.
Additional Components Available for Viper Pumps:
- Waterway Viper Shaft Seal Kit with Silicon, Tool, and Buna
- Waterway Viper Shaft Seal Kit with Single Bearing, Silicon, and Install Tool
- Waterway Viper Shaft Seal Kit with Dual Bearings, Silicon, and Install Tool
- Viper Face O-Ring for 2 1/2" x 2 1/2" Wet End
- Viper Impeller Wear Ring for 2 1/2" x 2 1/2" Wet End
- Viper Volute for 2 1/2" x 2 1/2" Wet End
- Viper Face Plate for 2 1/2" x 2 1/2" Wet End
- Mounting Screw 8-32 x 5/8" for WaterWay Executive, E-Series, Hi-Flo, Viper, Workman, EX2
- Bleeder Drain Plug with O-Ring 3/8" for Waterway Executive, Viper, Hi-Flo, Iron Might, Spa Flo, Supreme, Mustang, Workman
- O-Ring for 2 1/2" Pump Union fitting Viper Xp3 and Select Executive Models
This genuine closed face impeller is manufactured by Waterway Plastics specifically for Viper pump wet ends. Rated for 3.0hp operation, this impeller must be mounted on a 3.0hp or higher rated thru bolt motor for proper performance and safety.
Technical Specifications:
- Impeller Type: Closed Face
- Impeller Diameter OD: 3-13/16"
- Vane Width ID: 5/8"
- Eye Diameter OD: 2-5/8"
- Eye Length: 3/4"
- Impeller Width OD: 7/8"
- Seal Seat Depth: As specified for Viper series
