Description
This comprehensive maintenance kit includes a genuine Waterway Viper 3.0HP impeller, shaft seal assembly, single bearing, installation tool, and silicone lubricant. Designed specifically for Waterway Viper pumps featuring 2 1/2 inch inlet and outlet connections that measure approximately 3 9/16 inches across the threading. This 3HP pump impeller configuration is commonly paired with 10amp motors.
Important: The Viper pump series requires a unique seal design that differs from standard Waterway pump models. Compatible replacement components for this pump system include:
- Waterway Viper Shaft Seal Kit with Silicon and Tool Buna
- Waterway Viper Shaft Seal Kit featuring single bearing, silicon and installation tool
- Waterway Viper Shaft Seal Kit with dual bearings, silicon and installation tool
- Viper Face O-Ring for 2 1/2" x 2 1/2" Wet End Pump
- Viper Impeller Wear Ring for 2 1/2" x 2 1/2" Wet End Pump
- Viper Volute for 2 1/2" x 2 1/2" Wet End Pump
- Viper Face Plate for 2 1/2" x 2 1/2" Wet End Pump
- Mounting Screw 8-32 x 5/8" for WaterWay Executive, E-Series, Hi-Flo, Viper, Workman, EX2
- Bleeder Drain Plug with O-Ring 3/8" fits Waterway Executive, Viper, Hi-Flo, Iron Might, Spa Flo, Supreme, Mustang, Workman models
- O-Ring for 2 1/2" Pump Union compatible with Viper Xp3 and select Executive models
This closed face impeller is manufactured by Waterway Plastics exclusively for Viper pump systems. Rated for 3.0hp operation, it functions within a Waterway Viper pump wetend assembly and requires installation on a 3.0hp or higher thru bolt motor.
Technical Specifications:
Impeller Type: Closed Face
Impeller Diameter OD: 3-13/16"
Vane Width ID: 5/8"
Eye Diameter OD: 2-5/8"
Eye Length: 3/4"
Impeller Width OD: 7/8"
Seal Seat Depth: As specified by manufacturer
