Description
This is a full assembly Flo-Master FMCP wet end by Aqua-Flo rated at 1.5HP with 1-1/2" x 1-1/2" ports (threads measure approximately 2 3/8" across) featuring center discharge configuration for 48FR frame pumps. This assembly pairs with a 48 frame motor drawing approximately 9.0 Amps at High Speed when operating on 230V power or approximately 13.0 Amps at High Speed on 115V power. Compatible with both single speed and dual speed motors. Discharge orientation can be adjusted 90 degrees by rotating the assembly. This complete wet end package contains: volute housing, shaft seal, impeller, wear ring, suction cover, suction cover o-ring gasket, drain plug, drain plug o-ring gasket, and mounting screws for suction cover.
Important: Always select horsepower rating based on your motor's Amperage draw (refer to chart provided). A 48 frame motor has approximately 5 1/2" diameter, uses 1/4" thru-bolt heads, and has roughly 5 3/16" spacing between thru-bolts measured diagonally. A 56 frame motor has approximately 6 1/4" diameter, uses 5/16" thru-bolt heads, and has roughly 5 7/8" spacing between thru-bolts measured diagonally.
