2” PVC Fittings

This kit is used to convert the plumbing on some Dr. Wellness or Water's Edge Hot Tubs with a Chinese Energy Saver Control with an ET-H3000 or ET-H4000 remote heater that has the backwards unions to a more modern Control System set up.. NOTE: This is the...

This video is about The Spa Guy repairing a Leak on a 2" Soft Pipe Glue joint of tee connection instead of replacing the tee you use our RADKIT to repair the leak...    Save Save Save Save Save Save Save Save Save Save Save Save Save Save...

In this video The Spa Guy shows you how to repair a broken Hot Tub Pump Union without cutting plumbing out and using an Emergency Pump Union Split Nut Kit...      #sparepair #hottubrepair  #thespaguy #spaguy Save Save Save Save...

This video is about The Spa Guy repairing Freeze Damage on the large foot Master Blaster jet pipe under the center of the tub This tub is a Garden Leisure built by Dynasty...      #sparepair #hottubrepair  #thespaguy Save Save...

This part is a PVC Tee, 2"s x 2"s x 1"s.. You can make your connection back to the small side using the below kits..  Connect kit for 1" Soft pipe Click Here.. 1" Connect Kit Connect Kit for 1/2" or 3/4" Soft Pipe Click Here: 1/2" or 3/4" Connect...

This is a shorter than normal Coupler or Coupling, 2" Slip x 2" Slip, Short measures 2 7/16" and  is about 3/8" shorter than the normal coupling.. We do have another that is even shorter but it does not have as much surface for gluing so it will...

This part is a 90 Elbow, 2" Street x 2" Street.. This fitting measures about 2 3/8" OD on each end and would glue inside of 2" fittings that would measure about 2 3/8" ID..  PVC Pipe Fitting Type Ell, 90 deg First Plumbing Connection Size...

This part is a 45 Elbow, 2" Street x 2" Street.. This fitting measures about 2 3/8" OD on each end and would glue inside of 2" fittings that would measure about 2 3/8" ID..  PVC Pipe Fitting Type Ell, 45 deg First Plumbing Connection Size...

This Kit is a Barb Adapter, 3/4" Barb x 2" Spigot to 3/4" Slip Kit, Fits 2" Slip Water Manifolds that features (2) Clamps, 4" 3/4" ID Tubing and (1) 3/4" Barb to 3/4" Slip /1" Street Fitting that will glue inside of a 2" Slip Manifold or other 2"...

Reducer, 2" Spigot or Street x 1" Slip This part is used by gluing it into a 2" fitting which would measure about 2 3/8" Inside Diameter and then you could glue 1" Pipe or fitting inside of the 1" Slip fitting which would measure about 1 1/4" Outside...